Biochar production and use are part of the modern agenda to recycle wastes, and to retain nutrients, pollutants, and heavy metals in the soil and to offset some greenhouse gas emissions. Biochars from wood (eucalyptus sawdust, pine bark), sugarcane bagasse, and substances rich in nutrients (coffee husk, chicken manure) produced at 350, 450 and 750°C were characterized to identify agronomic and environmental benefits, which may enhance soil quality. Biochars derived from wood and sugarcane have greater potential for improving C storage in tropical soils due to a higher aromatic character, high C concentration, low H/C ratio, and FTIR spectra features as compared to nutrient-rich biochars. The high ash content associated with alkaline chemical species such as KHCO₃ and CaCO₃, verified by XRD analysis, made chicken manure and coffee husk biochars potential liming agents for remediating acidic soils. High Ca and K contents in chicken manure and coffee husk biomass can significantly replace conventional sources of K (mostly imported in Brazil) and Ca, suggesting a high agronomic value for these biochars. High-ash biochars, such as chicken manure and coffee husk, produced at low-temperatures (350 and 450°C) exhibited high CEC values, which can be considered as a potential applicable material to increase nutrient retention in soil. Therefore, the agronomic value of the biochars in this study is predominantly regulated by the nutrient richness of the biomass, but an increase in pyrolysis temperature to 750°C can strongly decrease the adsorptive capacities of chicken manure and coffee husk biochars. A diagram of the agronomic potential and environmental benefits is presented, along with some guidelines to relate biochar properties with potential agronomic and environmental uses. Based on biochar properties, research needs are identified and directions for future trials are delineated.

The addition of alkaline and high-cation exchange capacity (CEC) biochars is a suitable strategy to increase the CEC of weathered soils. The aim of this study was to evaluate the effect of biochar from different feedstocks and pyrolysis temperatures on the CEC of two contrasting Oxisols. Biochars produced from chicken manure (CM), eucalyptus sawdust (ES), coffee husk (CH) and sugarcane bagasse (SB),plus a control (without biochar), at 350, 450, and 750 °C were mixed with the soils at 2; 5; 10 and 20% (w/w) and incubated for 9 months. Feedstock, pyrolysis temperature and addition rate of biochar were key factors controlling the alteration of soil CEC. The CH biochar pyrolyzed at 350 °C was the most effective matrix at increasing soil CEC. In a rate-dependent way, ES and SB biochars increased C contents of both soils without improving soil CEC. The efficiency of high-ash biochars in enhancing soil CEC in both Oxisols was limited by the alkalization caused by high rates of CH and CM biochars. The increase in CEC is soil-dependent and modulated by high-ash biochar CEC and application rate, as well as by the original soil CEC.

The use of plant residues for energy purposes is already a reality, yet in order to ensure suitability and recommend a given material as being a good energy generator, it is necessary to characterize the material through chemical analysis and determine its calorific value. This research aimed to analyze different residues from plant biomass, characterizing them as potential sources for energy production. For the accomplishment of this study, the following residues were used: wood processing residue (sawdust and planer shavings); coffee bean parchment and coffee plant stem; bean stem and pod; soybean stem and pod; rice husk; corn leaf, stem, straw and cob; and sugar cane straw and bagasse. For residue characterization the following analyses were done: chemical analysis, immediate chemical analysis, calorific value and elemental analysis. All procedures were conducted at the Laboratory of Forest Biomass Energy of the Federal University of Lavras. In general, all residues showed potential for energetic use. Rice husk was found to have higher lignin content, which is an interesting attribute as far as energy production is concerned. Its high ash content, however, led to a reduction in calorific value and fixed carbon. The remaining residues were found to have similar energetic characteristics, with corn cob showing greater calorific value, followed by coffee plant stem, both also containing higher levels of carbon and fixed carbon. A high correlation was found of higher calorific value with volatile materials, carbon and hydrogen contents.

Brazilian Lignocellulosic Wastes for Bioenergy Production: Characterization and Comparison with Fossil Fuels

The objective of the present study was to evaluate lignocellulosic particles from sub-products of the coffee industry (coffee parchment - CP and husk - CH) into polyhydroxybutyrate (PHB) as a promising reinforcing filler in the biocomposites. The effects of type (CP or CH) and content (neat, 10% and 20%) of coffee wastes on the thermal, mechanical, microstructural and physical properties of the ensuing composites were evaluated. Thermal stability of the composites was improved by the coffee residues at different contents, while degree of crystallinity was decreased with the inclusion of CP. The addition of 10% of CP has not influenced significantly the tensile strength (TS) and Izod strength (IS), in relation to the neat PHB. Tensile strength (TS), MOE and Izod strength (IS) of the composites have increased significantly with the inclusion of 20% of CP. The increase in the content of coffee waste particles increased the water absorption of the composites.