Arailym Kamal

Dr. Arailym Kamal

Satbayev University, Almaty, Kazakhstan
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 November 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
Arailym KamalArailym Kamal
Arailym Kamal
AMArdak Makhatova
Ardak Makhatova
BYBakzhan Yergali
Bakzhan Yergali
ABAigerim Baidullayeva
Aigerim Baidullayeva
ASAliya Satayeva
Aliya Satayeva
Elizabeth ArkhangelskyElizabeth Arkhangelsky
Elizabeth Arkhangelsky
Landfill leachate, especially when produced in old municipal solid waste landfills, is a challenging type of wastewater which contains a variety of toxic substances. The existence of pollutants in the landfill leachate is primarily due to inadequate solid waste separation at the source. Pretreatment on site is a must for the landfill leachate to be safely released into the environment. One-step treatment is insufficient since landfill leachate has a complex composition that spatially and temporally varies. Often, the landfill leachate and municipal wastewater are treated together. Biological treatment is a routine technique which is applied to landfill leachate less than five years old. The concentration of easily biodegradable organic matter in the young landfill leachate declines with time and, as a result, the application of physical and chemical treatment processes is required. The goal of the current work is to investigate the usefulness and capability of the most efficient and widely available technique/s for landfill leachate treatment, to identify the main challenges and strengths of each technology and seek the optimum solution.

22 May 2020 in Membranes
Verified
Journal Article
Open access
PDF file
AOAlibek Omir
Alibek Omir
ASAliya Satayeva
Aliya Satayeva
ACAigerim Chinakulova
Aigerim Chinakulova
Arailym KamalArailym Kamal
Arailym Kamal
JKJong Kim
Jong Kim
Elizabeth ArkhangelskyElizabeth Arkhangelsky
Elizabeth Arkhangelsky
This study aims to examine the scaling and performance of flat sheet aquaporin FO membranes in the presence of calcium salts. Experiments showed that the application of calcium sulphate (CaSO4) resulted in an 8–78% decline in the water flux. An increase in the cross-flow velocity from 3 to 12 cm/s reduced the decline in the flux by 16%. The deposition of salt crystals on the membrane surface led to the alteration in the membrane’s intrinsic properties. Microscopy, attenuated total reflection-Fourier transform infrared (ATR-FTIR) spectroscopy, and X-Ray fluorescence (XRF) analyses confirmed measurements of the zeta potential and contact angle. The use of a three-salt mixture yielded severe scaling as compared with the application of calcium sulphate dehydrate (CaSO4 × 2H2O), i.e., a result of two different crystallisation mechanisms. We found that the amount of sodium chloride (NaCl), saturation index, cross-flow velocity, and flow regime all play an important role in the scaling of aquaporin FO flat sheet membranes.

6 November 2025 in Polymer
Verified
Journal Article
Closed access
Arailym KamalArailym Kamal
Arailym Kamal
BYBek Yergeldinov
Bek Yergeldinov
DNDamira Nygmetova
Damira Nygmetova
ASAliya Satayeva
Aliya Satayeva
JKJong Kim
Jong Kim
EAElizabeth Arkhangelsky
Elizabeth Arkhangelsky

20 December 2024 in Eurasian Journal of Ecology
Verified
Journal Article
Open access
PDF file
AUAL-FARABI KAZAKH NATIONAL UNIVERSITY
AL-FARABI KAZAKH NATIONAL UNIVERSITY
ASAliya Satayeva
Aliya Satayeva
Arailym KamalArailym Kamal
Arailym Kamal
JKJong Kim
Jong Kim
YAYelizaveta Arkhangelsky
Yelizaveta Arkhangelsky
ЕАЕлизавета Архангельски
Елизавета Архангельски
This study presents an analytical review of the micro/nanoplastic pollution problem in the wastewater and surface waters of the Republic of Kazakhstan. The review of published scientific works shows that analyzing micro- and nanoplastics (MNP) in the task due to their ubiquitous presence in natural habitats. This raises concerns because of their direct toxicological impact and their potential to carry hazardous pollutants and pathogens, thereby posing risks to human health and ecosystem integrity. MNPs have been detected in drinking water treatment processes, as well as in wastewater and surface waters in various regions of Kazakhstan. According to the studied data, there is a seasonal dynamic in the concentration of microplastics in water and bottom sediments, as well as in the wastewater of Astana city. It has been established that the predominant types of MNPs in surface waters are fibers, films, and granules, while polyethylene is prevalent in wastewater. Overall, the analysis of the current state of Kazakhstan’s environment in terms of micro/nanoplastic pollution indicates that such pollution exists and warrants close attention from scientists and environmental monitoring services.

30 June 2024 in NNC RK Bulletin
Verified
Journal Article
Open access
PDF file
Arailym KamalArailym Kamal
Arailym Kamal
DND. Nygmetova
D. Nygmetova
BYB. Yergeldinov
B. Yergeldinov
ASAliya Satayeva
Aliya Satayeva
JKJ. Kim
J. Kim
ДКДж. Ким
Дж. Ким
This study assessed the effectiveness of ceramic membranes in removing drugs from water. The effectiveness was assessed by filtration of model solutions with the addition of sulfamethoxazole and aspirin at a concentration of 3 mg/l. The study of drug concentrations was carried out using high-performance liquid chromatography (HPLC). The results showed 100% and 99.48% removal of aspirin and sulfamethoxazole from the solution, respectively. When filtering model solutions with the addition of medicinal substances, a decrease in the flow of solutions was observed over time and amounted to 19 l/m2-h for sulfamethoxazole and 30 l/m2-h for aspirin, respectively. Overall, the results obtained indicate that ceramic membranes have the potential to purify water from medicinal contaminants.

19 October 2026 in Membranes
Verified
Journal Article
Open access
PDF file
GDGulzat Demeuova
Gulzat Demeuova
ASAliya Satayeva
Aliya Satayeva
ZSZhanserik Shadiyar
Zhanserik Shadiyar
Alzhan BaimenovAlzhan Baimenov
Alzhan Baimenov
Elizabeth ArkhangelskyElizabeth Arkhangelsky
Elizabeth Arkhangelsky
Arailym KamalArailym Kamal
Arailym Kamal
Microplastics (MPs) are pervasive emerging contaminants in freshwater and drinking-water systems, and conventional treatment processes may achieve insufficient removal of smaller MP fractions. Membrane filtration provides an effective barrier to MPs; however, commercial ceramic membranes can be relatively expensive. In this work, low-cost porous ceramic membranes were fabricated by extrusion-based three-dimensional (3D) printing of a kaolin–rice husk paste, followed by sintering at 1200 °C. The removal of model spherical polyethylene (PE) and irregularly shaped polyethylene terephthalate (PET) MPs across different particle-size fractions was evaluated using dead-end filtration and benchmarked against a commercial ceramic membrane. The 3D-printed membrane removed 58.3 ± 3.6% of 1–10 µm PE particles, while complete removal was achieved for the 75–90, 300–355, and 600–710 µm PE fractions. For PET, removal efficiencies of 80.8 ± 0.9%, 94.9 ± 1.8%, and 100% were obtained for the 10–45, 45–75, and 75–150 µm fractions, respectively. By comparison, the commercial membrane achieved 100% removal across all PE and PET fractions tested. The fabricated membrane had a modal pore size of 0.80 µm and an estimated cost of USD 2.98, compared with USD 54.45 for the commercial 0.45 µm membrane. Thus, the 3D-printed membrane effectively removed medium and large MP fractions, while its estimated fabrication cost was approximately 94.5% lower than the purchase cost of the commercial membrane used for comparison. Although its larger pore size resulted in incomplete removal of the smallest MP fractions, the combination of effective removal of larger MPs and substantially lower estimated fabrication cost demonstrates the potential of extrusion-based 3D printing as an alternative approach for producing ceramic membranes for MP removal.