The injection of green hydrogen and biomethane is currently seen as the next step towards the decarbonization of the gas sector in several countries. However, the introduction of these gases in existent infrastructure has energetic, material and operational implications that should be carefully looked at. With regard to a fully blown green gas grid, transport and distribution will require adaptations. Furthermore, the adequate performance of end-use equipment connected to the grid must be accounted for. In this paper, a technical analysis of the energetic, material and operational aspects of hydrogen and biomethane introduction in natural gas infrastructure is performed. Impacts on gas transmission and distribution are evaluated and an interchangeability analysis, supported by one-dimensional Cantera simulations, is conducted. Existing gas infrastructure seems to be generally fit for the introduction of hydrogen and biomethane. Hydrogen content up to 20% by volume appears to be possible to accommodate in current infrastructure with only minor technical modifications. However, at the Distribution System Operator (DSO) level, the introduction of gas quality tracking systems will be required due to the distributed injection nature of hydrogen and biomethane. The different tolerances for hydrogen blending of consumers, depending on end-use equipment, may be critical during the transition period to a 100% green gas grid as there is a risk of pushing consumers off the grid.
The transition from natural gas to renewable gases such as biogas and hydrogen creates an interchangeability challenge. The laminar flame speed is a critical parameter in appliance design as it is a unique characteristic of the flame mixture. It is thus essential to evaluate the impact of renewable gases on . In this work, 1D simulations were conducted in Cantera with the USC-Mech 2.0 kinetic mechanism. The of three base biogas blends (BG100, BG90 and BG80) was computed for H2 enrichment up to 50% in volume, equivalence ratio , atm and K. It was found that the effect of H2 enrichment is higher for base blends with higher CO2 content as the thermal-diffusive and dilution effects of carbon dioxide are mitigated by hydrogen. The introduction of H2 also increases the H radical pool, which is linked with the increase in . A new correlation to model the impact of H2 enrichment, , is proposed, which exhibits good agreement with the literature data and simulations. This equation can be directly used to estimate without the need for a priori adaptations of fit parameters as the contributions of CO2 and H2 are isolated in independent variables.