Zinc oxide (ZnO) thin films were grown by atomic layer deposition using diethylzinc (DEZ) and water. In addition to depositions with normal water, heavy water (2H2O) was used in order to study the reaction mechanisms and the hydrogen incorporation at different deposition temperatures from 30 to 200 °C. The total hydrogen concentration in the films was found to increase as the deposition temperature decreased. When the deposition temperature decreased close to room temperature, the main source of impurity in hydrogen changed from 1H to 2H. A sufficiently long purging time changed the main hydrogen isotope incorporated in the film back to 1H. A multiple short pulse scheme was used to study the transient steric hindrance. In addition, the effect of the storage of the samples in ambient conditions was studied. During the storage, the deuterium concentration decreased while the hydrogen concentration increased an equal amount, indicating that there was an isotope exchange reaction with ambient H2 and/or H2O.
The elongation of spherical Au nanoparticles embedded in under swift heavy ion (SHI) irradiation is an extensively studied phenomenon. The use of a TEM grid as a substrate facilitates the identification of the same nanoparticle before and after the irradiation. Since the underdensification of inside the ion track plays a key role, the elongation is sensitive to the matrix material properties. Therefore, we studied the elongation process of SHI irradiated Au spherical nanoparticles of various diameters (5–80 nm) embedded either in atomic layer deposition (ALD) or plasma-enhanced chemical vapor deposition (PECVD) . The results show that a different elongation ratio is achieved depending on the particle initial size, ion fluence, and a different deposition method. The embedded nanoparticles in ALD elongate roughly 100% more than the nanoparticles embedded in PECVD at the biggest applied fluence ( ). On the other hand, at fluences lower than , nanoparticles elongate slightly more when they are embedded in PECVD .
Thin films are an effective way of manufacturing thermoelectric (TE) sensors for biomedical devices and wearable electronics. Excellent conformality and sub-nanometer thickness control of atomic layer deposition (ALD) make it a promising method of preparing TE thin films on flexible polymer and textile substrates suitable for sensor use. Here, Al-doped ZnO films were deposited on flexible perforated polyethylene terephthalate (PET) templates with 50/1 diethylzinc/trimethylaluminum pulsing ratio at a low temperature of 100 °C. Thermoelectric properties of the resulting nanocomposites were measured. The application potential of the present ALD-made TE coatings on flexible PET films for future roll-to-roll fabrication is discussed.
12 October 2021 in Semiconductor Science and Technology
Effective surface passivation of nano-textured silicon (NT-Si) using sputtered aluminum oxide (AlO x ) films is demonstrated and compared with the atomic layer deposition (ALD) grown AlO x films. Silver-assisted wet chemical etching is used to obtain sub-wavelength size features of black NT-Si, and then the NT-Si surface is chemically polished to minimize the surface defect states that act as trap centres for charge carriers. The NT-Si surface passivation is characterized by the density of interface trap states ( Dit ) and the fixed charge density ( Qf ), which also correlate with the surface recombination rate ( Seff ). For the sputtered AlO x films, the estimated Dit and Qf are ∼4 × 10 11 eV −1 cm −2 and ∼7 × 10 12 cm −2 , respectively, yielding the Seff of ∼34 cm s −1 . Whereas, for the ALD AlO x films the estimated Dit , Qf , and Seff are ∼1.6 × 10 11 eV −1 cm −2 , ∼7.4 × 10 12 cm −2 , and ∼20 cm s −1 , respectively. The chemical and field-effect passivation are evident for the ALD AlO x films with the reduced Seff . However, the sputtered AlO x films have shown only an indication of field-effect passivation with a small variation in the Qf . Still, the observed larger Dit is due to the sputtering damage on the NT-Si surface compared to ALD AlO x films.