Sand–clay mixtures can be encountered in both natural soils (e.g., residual soils, clay deposits and clinosols) and artificial fills. The method of utilising biopolymers in ground improvement for sand–clay mixtures has emerged recently. However, a full understanding of the strengthening effect of biopolymer-treated sand–clay mixtures has not yet been achieved due to a limited number of relevant studies. In this study, xanthan gum (XG), as one of the eco-friendly biopolymers, was used to treat reconstituted sand–clay mixtures that had various compositions in related to clay (or sand) content and clay type (kaolin and bentonite). A series of laboratory unconfined compression strength (UCS) tests were conducted to probe the performances of XG-treated sand–clay mixtures from two aspects, i.e., optimum treatment conditions (e.g., XG content and initial moisture content) to achieve the maximum strengthening effect and strengthening efficiency for the sand–clay mixtures with different compositions. The experimental results indicated that the optimum initial moisture content decreased as the sand content increased. The optimum XG content, which also decreased with the increasing sand content, remained approximately 3.75% for all sand–kaolin mixtures and 5.75% for all sand–bentonite mixtures if calculated based on clay fraction. While untreated sand–kaolin mixtures and sand–bentonite mixtures had comparable UCS values, XG-treated sand–kaolin mixtures seemed to have better improved mechanical strength due to higher ionic (or hydrogen) bonds with XG and low-swelling properties compared with bentonite. The deformation modulus of XG-treated sand–clay mixtures were positively related with UCS. The variation in UCS and stiffness for each treatment condition increased as the sand content was elevated for both sand-kaolin and sand-bentonite mixtures. An increment in the proportion of the heterogeneous composite formed by irregular sand particles conglomerated with the XG–clay matrix in total soil might be responsible for this phenomenon.

The understanding of cyclic and post-cyclic behaviours of the soil–geosynthetic interface is essential for the design of geosynthetic- reinforced soil structures under repeated loads, such as those induced by traffic, earthquakes and compaction. In this paper, a series of monotonic direct shear tests and cyclic direct shear integrating monotonic direct shear tests were conducted by using a large-scale direct shear testing device. The effect of normal stresses, cyclic shear amplitude and cycle number on the post-cyclic behaviour of the interface are investigated. In addition, the influence of cyclic shear on interface direct shear behaviour was discussed in detail. The test results indicated that both the peak and residual shear stresses of the interface during the post-cyclic shear phase increased linearly with normal stress and the number of cycles. The volume contraction, which was induced by the direct shear, decreased with the increase in normal stress. The interface apparent adhesion and friction angle increased with the cyclic shear.

In the last decade, biopolymers have been used as organic soil binders in ground improvement and earthen construction material modification. Although biopolymer-treated soils have substantially enhanced mechanical strength, the deformation characteristics under external loads and material durability (e.g. biodeterioration due to microbial activity) have not yet been fully understood, which limits the in situ practical application of the biopolymer-based soil treatment technology. This study investigated the efficiency of combined carrageenan and casein in strengthening a clayey soil with the biodeterioration consideration. Both mechanical tests (e.g. unconfined compressive strength and one-dimensional consolidation) and biological tests (e.g. high throughput sequencing and rating of mould growth) were conducted. Results indicated that the usage of the carrageenan–casein mixture induced a higher soil compressive strength compared with either carrageen or casein, due to the formation of a three-dimensional gel network. In addition, carrageenan–casein mixture and casein decreased the compressibility of the clayey soil, which might be attributed to the casein’s peculiarity of self-associating into micelles, leading to minimal interactions with water molecules. Carrageenan, due to its affinity for water, increased the soil compressibility. Under the impact of microbial activity, the biopolymer-treated soils underwent deterioration in both surface appearance (i.e. coloured stains and patches caused by mould growth) and compressive strength. A linear relationship was proposed, in which a reduction in compressive strength by approximately 11% is expected while the rating of mould growth is increased by one in a five-rating system. The current research demonstrates that the soil reinforcement with combined carrageenan and casein is able to improve both soil strength and deformation behaviours. It is also suggested to take into account the biodeterioration considerations in the design and implementation of biopolymer-based soil reinforcement practices.