Girdhari Chaudhary

Dr. Girdhari Chaudhary

Division of Electronics Engineering, Jeonbuk National University (JBNU), Jeonju-si 54896, Korea
orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 July 2018 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
BABoram An
Boram An
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
YJYongchae Jeong
Yongchae Jeong
This letter presents a design for a wideband reflection-type tunable phase shifter (RTPS) with a low in-band phase deviation error. The proposed RTPS consists of a 3-dB hybrid where a through port and a coupled port are terminated with coupled lines, varactor diodes, and a capacitor. The measured capacitance of the varactor diodes was used in the analysis to take into account the in-band phase deviation error caused by the parasitics of the varactor diode. The analysis shows that the desired phase shifting range (PSR) and a low in-band phase deviation error can be obtained by properly selecting the characteristic impedance and coupling coefficient of the coupled line and load capacitance. The experimental results show that the fabricated RTPS provides a PSR of 146.93° at 2.5 GHz and an in-band phase deviation error of ±5.79° within 500 MHz. Moreover, the input-output return losses are higher than 15.76 dB, and the insertion loss is smaller than 1.29 dB within the operating frequency band.

8 November 2021 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
YJYongchae Jeong
Yongchae Jeong
This letter presents a magnet-less nonreciprocal bandpass filter (BPF) that uses coupled static and time-modulated resonators. This coupling allows the nonreciprocal BPF to achieve minimum forward insertion loss (IL) and two pole isolation within the passband and shows wideband and high isolation. The modulation signal is directly applied to the varactor through the transmission line. This design, while simple, nevertheless achieves an excellent nonreciprocal response. We designed, simulated, and experimentally validated a microstrip line nonreciprocal BPF at 1.46 GHz. The results achieved in experiment were consistent with those obtained through simulations; forward IL of 3.10 dB and reverse isolation of 20 dB over a bandwidth of 50 MHz.

25 August 2021 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
YJYongchae Jeong
Yongchae Jeong
In this article, we present a frequency tunable magnetless nonreciprocal bandpass filter (BPF) that uses time-modulated quarter-wave microstrip line resonators. The proposed nonreciprocal BPF can transform real-to-real, real-to-complex, and complex-to-complex termination impedances. To achieve nonreciprocity, a modulation signal is directly applied to the varactor through the transmission line. The modulation scheme in the proposed nonreciprocal BPF, while simple, nevertheless achieves an excellent nonreciprocal response. The center frequency ( f 0 ) and nonreciprocal response of the proposed BPF are tuned by changing the dc bias voltage of the varactor. The design is validated by experiments using four prototypes of nonreciprocal BPFs (filter A: 50-to-50 Ω, filter B: 20-to-50 Ω, filter C: 25+ j 10-to-50 Ω, and filter D: 25+ j 10-to-55+ j 10 Ω). The measured results confirm that the f 0 of the nonreciprocal BPF is tuned from 1.64 to 1.97 GHz (330 MHz) with a forward insertion loss variation of 4.96 to 3.94 dB and backward isolation of 20 dB over a bandwidth of 50 MHz.

3 April 2019 in IEEE Access
Verified
Journal Article
Open access
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
JJJunhyung Jeong
Junhyung Jeong
YJYongchae Jeong
Yongchae Jeong
This paper presents a novel design of high self-interference cancellation (SIC) technique for microstrip antennas. The proposed antenna consists of two closely-spaced orthogonal antennas with differential feeding as SIC circuit so as to achieve high interport isolation between the transmitter and receiver. In order to achieve high RF leakage cancellation, a novel differential feeding network (DFN) is also proposed in this work, which provides amplitude and outof-phase imbalances within 0.12 ± 0.03dB and -180 ± 1°, respectively, for bandwidth of 500 MHz at center frequency of 2.50 GHz. General analytical design equations are derived for achieving high SIC over the wide bandwidth. For experimental validation, prototypes are designed and fabricated at the center frequency of 2.50 GHz using an FR-4 substrate with dielectric constant of 4.4 and loss tangent of 0.02. Good agreement is observed among the theoretical analysis, the simulation and measurement results. The first fabricated prototype provides more than 64 dB SIC for bandwidth of 110 MHz, while the second prototype achieved more than 60 dB SIC for 160 MHz bandwidth. In addition, the SIC of the antenna using the proposed DFN is high over the wideband frequency bandwidth as compared to conventional 180o ring hybrid feeding network. Due to ease of implementation and excellent performances, the proposed antennas have potential application for wideband in-band full duplex systems. INDEX TERMS Analog cancellation, differential feeding network, high RF isolation, passive suppression, in-band full duplex (IBFD), wideband self-interference cancellation (SIC).

19 June 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
YJYongchae Jeong
Yongchae Jeong

3 July 2023 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
Girdhari ChaudharyGirdhari Chaudhary
Girdhari Chaudhary
YJYongchae Jeong
Yongchae Jeong
This article presents RF design and practical implementation of a nonreciprocal filtering power divider that enables arbitrary power division ratio ( $k^{2})$ and center frequency tunability. By modulating resonators in the filtering power divider with progressive phase shift sinusoidal modulation signals, a nonreciprocal response ( $\vert S_{21}\vert$ $\ne $ $\vert S_{12}\vert$ and $\vert S_{31}\vert$ $\ne $ $\vert S_{13}\vert)$ is achieved. The analytical spectral S-parameters of nonreciprocal filtering power divider have been derived for insight analytical nonreciprocal frequency response and practical implementation. The proposed analytical equations can be applied to design a nonreciprocal filtering power divider with arbitrary $k^{2}$ and any arbitrary termination port impedances. Center frequency tunability can be achieved by tuning the resonant frequencies of time-modulated resonators. For experimental validation, prototypes of nonreciprocal filtering power dividers with $k^{2}$ $=$ 1 and $k^{2}$ $=$ 0.5 are designed, implemented, and manufactured. The measured results confirm the accuracy of the analytical design equations. In the experimental results, the center frequency of nonreciprocal filtering power dividers is tuned from 1.66 to 1.98 GHz (17.58%) with a maximum forward insertion loss of 4.95 dB and reverse isolation ( $\vert S_{12}\vert$ and $\vert S_{13}\vert)$ higher than 20 dB at each center frequency tuning state.