The coating of polyurea elastomers on walls is a hotspot in the protection field. This work combines a numerical simulation with experimental validation to examine the blast resistance after coating a polyurea elastomer on a 370 mm wall under a contact explosion. Firstly, the failure limit, failure mode, and failure mechanism of the 370 mm unreinforced wall under different strength loads are studied. In the case of the contact explosion, the increase in size of the 370 mm wall blasting pit gradually stops after the dose is increased to more than 1 kg. Thereafter, the energy of the explosive load wis released by splashing wall fragments as well as by the deflection and movement of the wall. Spraying double-sided polyurea reinforcement on the wall can effectively improve the resistance to damages caused by exposure to explosive loads and can inhibit the damage to the surrounding personnel and equipment caused by flying structural debris. When the polyurea thickness on the front surface is 6 mm, the optimal thickness of the back surface should be 2 mm.
How to effectively reduce the damage of frequent accidental explosions and explosion attacks to existing walls is an important concern of the blast resistance field. In the present study, the influence of the foamed concrete (density 820 kg/m3, water-cement ratio 0.4) coating thickness on the blast resistance of a 120 mm RC (reinforced concrete) wall was studied through blast experiments, numerical simulations, and shock wave theory. Results show that the influences of foamed concrete on the blast resistance of RC walls are jointly decided by the stress drop caused by impedance effect and exponential attenuation and the stress rise caused by high-speed impact compression. The coating thickness mainly affects the foam concrete’s fragmentation degree and stress attenuation. A lower critical coating thickness exists in foamed concrete-coated RC walls. The blast resistance of the RC wall will decrease when the coating thickness is less than that value. The lower critical coating thickness is related to the intensity of blast load and the energy absorption capacity of foamed concrete, and it can be predicted by monitoring the explosive stress and energy incident to the RC wall.
21 October 2025 in ACS Sustainable Chemistry & Engineering
Energetic materials, essential for rocket propulsion, play a crucial role in aerospace systems. These materials lack sufficient safety assessments and pose significant risks to life and infrastructure. The slow progress in this field is hindered by prohibitively high experimental costs and the inherently destructive nature of these experiments. This study aimed to evaluate modeling-based safety assessments, primarily utilizing the Lee–Tarver model. It specifically addressed the threat posed by shaped charges during transportation. Experimental analyses employed 50 mm JH-2 shaped charges, targeting RDX-based JH-2 formulation, since RDX is widely used in various rocket motor propellant formulations. TNT was also used to enhance the validation of the Lee–Tarver model findings. Various logistical configurations were explored, testing steel container walls ranging from 10 mm thickness to reinforced walls of 50 mm, 60 mm, and 65 mm steel. Comparative analysis with experiments reinforced the accuracy of the Lee–Tarver model’s numerical predictions. Both simulations and experiments affirmed that a 65 mm steel protection suffices for the safe transportation of RDX-based JH-2 formulations and TNT within a 10 mm storage box in logistical setups. Furthermore, this study emphasizes the Lee–Tarver model’s reliability for most energetic materials safety assessments, while acknowledging certain limitations.