In a resorption heat pump, the adsorption and desorption reaction of ammonium chloride (NH4Cl) with ammonia (NH3) is of interest as a Low Temperature Salt (LTS). Reviewing previously published NH4Cl-NH3 equilibrium lines, ammonium chloride appears to offer useable working temperatures (50–70 °C) in the 10–15 bar pressure range during the adsorption reaction, and provides beneficial working conditions for the desorption reaction, when compared with alternative LTS candidates at atmospheric pressure. The NH4Cl-NH3 adsorption and desorption reactions, using a NH4Cl composite salt, have been evaluated under dynamic ‘real-world’ conditions in a Large Temperature Jump (LTJ) experimental testing rig; although there are concerns with mass transfer characteristics, the salt exhibits no hysteresis between the adsorption and desorption reactions, contrary to previous literature. The experimentally obtained equilibrium line values for the reaction enthalpy and entropy are 29,835 J/mol and 207 J/(mol∙K), respectively. Using a semi-empirical model, the NH4Cl composite salt has been successfully characterised, enabling the prediction of salt reaction behaviour. The model constants, A and n, identified are 4.5 and 5 for adsorption and 5 and 4 for desorption, with an overall salt active fraction (applicable to both reactions) of 0.98. Overall, the working equilibrium line and the dynamic performance of ammonium chloride has been investigated and the applicability of NH4Cl as a LTS for a resorption heat pump determined.
This work takes an empirical and evidence-based approach in the development of a resorption thermal transformer. It presents the initial modelling conducted to understand key performance parameters (coefficient of performance and specific mean power) before discussing a preliminary design. Experimental results from large temperature jump and isosteric heating tests have identified the importance of heat transfer in ammonia-salt systems. Both the heat transfer resistance between the salt composite adsorbent and the tube side wall, and the heat transfer from the heat transfer fluid to the tube side wall are key to realising resorption systems. The successful performance of a laboratory-scale prototype will depend on the reduction in these heat transfer resistances, and improvements may be key in future prototype machines. A sorption reactor is sized and presented, which can be scaled for length depending on the desired power output. The reactor design presented was derived using data on reaction kinetics constants and heat of reaction for calcium chloride reacting with ammonia that were obtained experimentally. The data enabled accurate modelling to realise an optimised design of a reactor, focusing on key performance indicators such as the coefficient of performance (COP) and the system power density. This design presents a basis for a demonstrator that can be used to collect and publish dynamic data and to calculate a real COP for resorption system.