In recent years, several new applications of SiC (both 4H and 3C polytypes) have been proposed in different papers. In this review, several of these emerging applications have been reported to show the development status, the main problems to be solved and the outlooks for these new devices. The use of SiC for high temperature applications in space, high temperature CMOS, high radiation hard detectors, new optical devices, high frequency MEMS, new devices with integrated 2D materials and biosensors have been extensively reviewed in this paper. The development of these new applications, at least for the 4H-SiC ones, has been favored by the strong improvement in SiC technology and in the material quality and price, due to the increasing market for power devices. However, at the same time, these new applications need the development of new processes and the improvement of material properties (high temperature packages, channel mobility and threshold voltage instability improvement, thick epitaxial layers, low defects, long carrier lifetime, low epitaxial doping). Instead, in the case of 3C-SiC applications, several new projects have developed material processes to obtain more performing MEMS, photonics and biomedical devices. Despite the good performance of these devices and the potential market, the further development of the material and of the specific processes and the lack of several SiC foundries for these applications are limiting further development in these fields.

The component of orbital angular momentum (OAM) in the propagation direction is one of the fundamental quantities of an electron wave function that describes its rotational symmetry and spatial chirality. Here, we demonstrate experimentally an electrostatic sorter that can be used to analyze the OAM states of electron beams in a transmission electron microscope. The device achieves postselection or sorting of OAM states after electron-material interactions, thereby allowing the study of new material properties such as the magnetic states of atoms. The required electron-optical configuration is achieved by using microelectromechanical systems technology and focused ion beam milling to control the electron phase electrostatically with a lateral resolution of 50 nm. An OAM resolution of $1.5\hslash$ is realized in tests on controlled electron vortex beams, with the perspective of reaching an optimal OAM resolution of $1\hslash$ in the near future.

This is the author accepted manuscript. The final version is available from Elsevier via http://dx.doi.org/10.1016/j.sna.2016.01.00

3C-SiC is an emerging material for MEMS systems thanks to its outstanding mechanical properties (high Young’s modulus and low density) that allow the device to be operated for a given geometry at higher frequency. The mechanical properties of this material depend strongly on the material quality, the defect density, and the stress. For this reason, the use of SiC in Si-based microelectromechanical system (MEMS) fabrication techniques has been very limited. In this work, the complete characterization of Young’s modulus and residual stress of monocrystalline 3C-SiC layers with different doping types grown on and oriented silicon substrates is reported, using a combination of resonance frequency of double clamped beams and strain gauge. In this way, both the residual stress and the residual strain can be measured independently, and Young’s modulus can be obtained by Hooke’s law. From these measurements, it has been observed that Young’s modulus depends on the thickness of the layer, the orientation, the doping, and the stress. Very good values of Young’s modulus were obtained in this work, even for very thin layers (thinner than 1 μm), and this can give the opportunity to realize very sensitive strain sensors.