Sławomir Grycuk

Mr. Sławomir Grycuk

Bialystok University of Technology, Białystok, Podlaskie, Poland
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 April 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SGSławomir Grycuk
Sławomir Grycuk
PMPiotr Mrozek
Piotr Mrozek
This article presents the results of numerical finite element method (FEM) simulations in the Ansys environment of a Boston orthopaedic brace. The geometric model was developed based on the results of digitisation performed by means of a three-dimensional (3D) optical scanner. A test stand for measurement of the brace’s field of displacements, utilising a laser electronic speckle pattern interferometer (ESPI), was used to experimentally verify the FEM model. During experimental testing, special attention was given to applying the loads and boundary conditions used in the numerical simulations. As a result, the relative difference between the experimentally and numerically determined displacements in the central part of orthoses amounted to approximately 0.6%. The experimentally verified FEM model was used to determine the force flow lines characteristic of the brace, indicating the general working method of the brace’s structure. The primary parts of the orthoses, carrying loads correcting the spine and the position of sites exerting little effort from the perspective of their participation in the orthoses’ essential therapeutic application were identified. The results obtained allow for the proposal of methods for mechanical optimisation of the brace’s design. The analysis conducted is universal in nature and can be adapted to other types of orthopaedic braces.

15 December 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SGSławomir Grycuk
Sławomir Grycuk
PMPiotr Mrozek
Piotr Mrozek
Orthoses are of critical importance in the field of medical biomechanics, particularly in the correction of spinal deformities. The objective of the current research was to improve the utility characteristics of the scoliosis brace without compromising its corrective capabilities. The orthotic shell of the Boston brace was used as the basis for this investigation. The finite element method (FEM) was used to evaluate the distribution of corrective forces through the device. The flow of force lines within the orthotic shell was determined by mapping the paths of maximum principal stresses. Areas of the device that had a negligible effect on overall stiffness were identified and material from these areas was eliminated. Minor modifications were then made to the redesigned shell to maintain its corrective stiffness. As a result of these changes, the weight of the braces was reduced without compromising its corrective stiffness. When subjected to corrective forces, the shell’s displacement patterns in the transverse plane showed minimal changes from the original model, confirming that its corrective capacity remained largely intact. This research presents an innovative methodology for orthotic design and demonstrates that structural optimization based on the mapping of maximum principal stress pathways can significantly improve device functionality. The approach outlined here holds promise for future advances in the design of various orthotic devices, thereby contributing to the advancement of the field.

4 September 2021
Verified
Book Chapter
Closed access
PDF file
SGSławomir Grycuk
Sławomir Grycuk
PMPiotr Mrozek
Piotr Mrozek