The plasmonic enhanced absorption of thin-film organic solar cell (OSC) with silver nanoparticles has been simulated and analyzed in the two-dimensional (2-D) and three-dimensional (3-D) simulation models by considering the position of nanoparticles inside the OSC and the incident angle and polarization of the incident light. It is found that, for TM polarization incidence, obvious optical absorption enhancement is obtained in both 2-D and 3-D cases. The absorption enhancement reaches more than 200% with nanoparticles deposited at the interface of PEDOT:PSS and P3HT:PCBM layer, which is larger than that with nanoparticles inside the active layer. However, for TE polarization incidence, the optical absorption is worsened rather than enhanced with metal nanostructures in the 2-D model, which is different with the results derived in the 3-D model. The absorption enhancement characteristics are also studied at oblique incidence, and the high absorption enhancement as high as 160% can be also obtained when the incident angle is increased to 60 ° in the 3-D model. By analyzing the mode profile in different circumstances, it could be concluded that the localized surface plasmon plays a significant role on improving the light absorption enhancement of OSC.
Laser cleaning of metallic alloys for the purpose of removal of metal oxide layers is based on laser thermal ablation. In laser thermal ablation, the interaction between the laser beam and oxide layer may generate significant thermal effects to induce additional thermal oxidation or even melting a thin layer of the underlying surface. The change of surface oxide status may subsequently affect corrosion behavior of the metallic alloys. In this work, the effects of laser cleaning on corrosion behavior of hot-rolled AA5083-O aluminum alloy were investigated using electrochemical impedance spectroscopy. The results showed that the laser-cleaned surfaces exhibited higher corrosion resistance in 3.5 wt. % NaCl solution than the as-received alloy, with a significant increase in impedance and reduction in capacitance. The corrosion behavior was correlated to the change of surface oxide status measured by glow discharge optical emission spectrometry, x-ray photoelectron spectroscopy, and high-resolution transmission electron microscopy. It was concluded that the laser cleaning removed the original, less protective oxide layer consisting of a discontinuous MgO/MgAl2O4 outer layer (∼20 nm) and MgO/MgAl2O4 particles dispersed inner layer (∼300 nm) on the as-received surface but resulted in the formation of more protective oxide layer containing mainly Al2O3 and MgO, which were responsible for the improvement of the corrosion performance. The laser fluence played an important role in determining the thickness of the newly formed oxide layers that subsequently affected the corrosion performance of laser-cleaned alloy.