Everyone who drinks bottled water contributes at least 17 kg to the post‐consumer poly(ethylene terephthalate) (W‐PET) accelerating the accumulation of the waste plastics (WP) that already have an annual rate of increase of ~4.5%. Disposals of W‐PET mimics a pseudo‐renewable resource of WP, that creates many recycling and economic opportunities. This work presents a recycling method that reduces the burden of W‐PET on the environment while saves energy and creates new economic opportunities. The recovered purified PET (PET‐R) that its thermal properties are reported here was obtained by solvent extraction method. Five samples of PET‐R were analyzed by thermogravimetry to study its kinetics properties assuming that the degradation process followed a pseudo‐single component model. The isoconversional Ea,α values obtained from the f(α) functions were comparable to each other by the average and standard deviation of 200 ± 5 kJ mol−1; which is very close to the value of Ea of pure PET. The results were consistent with kinetics data reported in the literature for pure PET.
23 February 2019 in Journal of Macromolecular Science, Part B
The thermal decomposition of post-consumer samples of a carbonated water bottle made of poly(ethylene terephthalate), PC-PET, was examined by linear temperature programing under an argon atmosphere to determine its mass loss kinetics. A simple kinetic model, called the first order pseudo single-component model, was used. The total weight-loss of each sample assumed to be in two periods, with each period corresponding to a one step decomposition of the PC-PET to volatiles. Three methods for determining the kinetic parameters by thermal gravimetric analysis were examined: differential analysis at a constant heating rate (differential), temperatures of a given conversion at a number of heating rates (isoconversional), and the maximum rate at multiple heating rates (peak temperature). The latter two multiple heating rates methods results were comparable to each other but they were not in agreement with the results from the differential method. The results of the differential method were insensitive to the heating rate and consistent with kinetics data reported in the literature for PET.
3 June 2022 in Journal of Macromolecular Science, Part B
Expanded polystyrene foams (EPS) are used as packaging materials and are often discarded by consumers after the goods are unpacked (WEPS). Most recycling centers do not accept them because their extremely low weight makes them uneconomic to transport. In the research described here, WEPS was collected from shipping containers and crushed in a blender into 2-4 mm spherical shapes that were used as a replacement for aggregates to make lightweight concretes (LWC) to build lightweight facilities. Eight types of concrete samples were prepared, with the WEPS replacing the natural aggregate at the levels of 0 to 85 percent by volume to study the effects of the WEPS on the properties of the LWC. The densities of the LWCs were less than that of those found from natural aggregate (NAG), as was expected (900–1700 kg/m3). The heat conductivity of the LWC samples was smaller than that of NAG when the composition of WEPS was below 50%. The 28-day compressive strengths of the LWC ranged from 11 MPa to 90 MPa, which satisfies the strength requirement of semi-structural LWC recommended by ASTM to be higher than 17 MPa.