In the pursuit of more efficient vehicles on the world’s roads, the vehicle thermal management system has become a limiting factor when it comes to EV range and battery life. In extreme climates, if the thermal system cannot pull down or warm up the EV powertrain in a timely manner, the battery is at serious risk of capacity loss or accelerated degradation. As waste heat is inherently limited with EVs, the way in which we provide the heat for warm-up must be as efficient as possible to reduce the load on the battery. In this paper, a revolutionary waste heat recovery (WHR) thermal management system designed by Tesla, nicknamed the ‘Octovalve’, is described, modelled, and simulated. This paper contributes to collective knowledge by presenting an in-depth breakdown of the key operating modes and outlining the potential benefits. Modelled in the multidomain Simulink Simscape software, the octovalve’s performance is directly compared to a typical EV WHR thermal management system. The system under analysis is shown to significantly reduce EV energy consumption and battery load during warm-up but at the cost of overall warm-up time. Unlike any other WHR system found in literature, this system has a heat pump with can perform air conditioning and heat pump tasks simultaneously, which is shown to have a remarkable impact on energy efficiency and battery life.
Improving the architecture and control strategies of thermal management systems (TMSs) is crucial for minimizing energy consumption in heating and cooling components, thereby enhancing the driving range of Battery Electric Vehicles (BEVs). This study presents a holistic approach for developing an Integrated Thermal Management System (ITMS) based on an Octo-valve-type architecture, designed to efficiently manage the thermal demands of both the cabin and powertrain components. Empirical data were collected under various heating and cooling scenarios across a wide operating temperature range (−20 °C to 40 °C), and these data were used to parametrize and validate key ITMS components. Experimental results demonstrated that the parametrized simulation model closely replicated the cabin and battery thermal behavior observed in vehicle tests, particularly under cooling conditions. Minor deviations, such as cabin temperature overshoot during heating scenarios, were attributed to duct thermal effects and control tuning limitations. Overall, the optimized Octo-valve-based ITMS architecture exhibited thermal trends consistent with literature references and effectively validated the proposed control strategy, demonstrating improved thermal efficiency and potential range enhancement for BEVs across diverse environmental conditions. Furthermore, ITMS energy consumption over the indicated temperature range is quantified in this research paper.
A robust experimental-based vehicle drive system model and parameters tuned to match the real-world performance of the electro-mechanical systems is presented. The model is based on battery electric vehicle systems, focusing on the individual components of the drive system. The model includes motors, a battery pack, a driveline, and a DC-DC converter. Based on the collected empirical data using an on-board data acquisition system, and fine-tuning the critical vehicle parameters to align the simulation with the empirical data, stationary and drive cycle tests were designed and performed to replicate standard day-to-day driving conditions. Performance metrics such as the power consumption, the state of charge and the range were employed for the model validation. The validated model was then used for the performance study at different operating temperatures. The results of the study demonstrate that the model successfully mirrored the performance of the powertrain under various conditions and lined up with existing research work, providing a valuable tool for further research and development in battery electric vehicle technology.