During the underwater LiDAR imaging process, the images achieved by the conventional constant threshold adjacent frame difference (AFD) method normally loses the distance information of targets. This is mainly due to the Gaussian distribution of the laser light intensity field, which leads to the inhomogeneous intensity distribution in the frame from the target acquired by intensity charge-coupled devices (ICCD). In order to overcome this issue, the novel dynamic threshold adjacent frame difference (DTAFD) method was proposed in this paper. The DTAFD method modifies the intensity threshold following the pixel intensities in the different parts of the single frame intensity image acquired by ICCD. After the detailed theoretical demonstration of the DTAFD method, with the purpose of verifying its feasibility, the self-developed range-gated flash imaging LiDAR has been employed to construct the distance images of the rectangular and circular shaped targets at different distances. The distance between the rectangular target and the LiDAR system is 25.7 m, and the circular target is 70 cm further away from the rectangular target. The full distance information of these two targets is obtained by the DTAFD method with an effectively suppressing noise and the PSNR is increased from dB to dB. The experimental results indicate that the DTAFD method efficiently solves the AFD method’s drawback on the target information loss caused by the unequal optical field distribution, which makes it more suitable for the scenarios with uneven laser distribution such as the underwater imaging environment.
The attenuation coefficient of a water body is one of the important factors for describing its features. However, its remote measurement in real time is still a challenge. In this paper, we demonstrated a novel method to realize real-time remote measurements of the attenuation coefficient of fresh water using flash imaging lidar based on the adjacent frame difference (AFD) method and a water body backscattering model. In general, we firstly investigated the relationship between the backscattering intensity and the attenuation coefficient based on the backscattering model of the water body. Then, the backscattering intensity at the front and back edges of the range-gate obtained by the AFD method was brought into this relationship to obtain the attenuation coefficient. Experiments on the measurements of the average attenuation coefficient of the 532 nm laser in fresh water at 3–8 m were further carried out using our self-developed flash lidar with the AFD method. The acquired water attenuation coefficients were and with a delay step time of 1 ns and 2 ns in the AFD method, respectively. We compared these values to the one achieved following the conventional Beer–Lambert law (), and they matched well with each other. These results fully illustrated the feasibility and reliability of the proposed method for measuring the attenuation coefficient of water bodies.
In this paper, we proposed a stepping equivalent range-gate method (S-ERG method) to measure the speed and the distance of the moving target for range-gated imaging lidar. In this method, the speed is obtained by recording the time at which the moving target passes the front and back edges of the range gate, the distance information can also be obtained by the front and back edges of the range gate at the same time. To verify the feasibility of this method, a stationary target and a moving target with different speeds were measured by the S-ERG method. By using the S-ERG method, we not only obtained the distance information of the stationary target and the moving target at the front and back edges of the range gate, respectively, but also obtained the speed of the moving target. Compared to speeds measured by rotational displacement sensors, the speed measurement error of the S-ERG method is less than 5%, whether the target is far away or close to the range-gated lidar system, and this method is almost independent of the delay step time. The theoretical analysis and experimental results indicate range-gated imaging lidar using the S-ERG method has high practicality and wide applications.
2 September 2026 in Optics and Lasers in Engineering