Aircraft soot has a significant effect on the air quality and human health. The aim of this study is to investigate the evolution of soot morphology in free jet laminar diffusion flames between Chinese traditional aviation kerosene RP-3 and algae-based aviation biofuels. The differences in height, profile, and structural properties of soot between the RP-3 flame and biofuel flame are determined. A laboratory-made probe sampling method was applied for soot sample collection. Transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM), X-ray diffraction (XRD), and elemental analyzers were used to analyze the collected soot particles. The average particle size of soot increases first and then decreases in both flames, and the size of biofuel primary particles is smaller than that of jet fuel RP-3 particles along the same flame height. At the flame tip, the primary particle sizes of RP-3 soot and biofuel soot are 22.7 and 15.6 mm, respectively. In comparison with the RP-3 soot, the nanostructure of biofuel soot particles along the same flame height exhibits a shorter fringe lattice, a larger fringe tortuosity, and a larger interlayer spacing, which indicate a higher degree of oxidation reactivity. Meanwhile, RP-3 soot particles have a lower H/C atom ratio and have greater intensity in X-ray diffraction, which indicates a more orderly and compact lattice structure. This study provides some references in studying the algae-based biofuel with regard to soot formation.
12 February 2021 in Journal of Energy Resources Technology
Oxygen concentration is a significant factor affecting soot formation and oxidation. However, there are few studies that have focused on the morphology and nanostructure characteristics of soot in aviation kerosene, oxygen-depleted combustion flames. In the present paper, five coflow flames under initial oxygen volume concentrations of 18.5%, 19%, 20%, 21%, and 23.5% were studied. The pneumatic probe sampling method and high-resolution transmission electron microscopy (HRTEM) analysis were conducted to quantify the morphology and nanostructure parameters, and laser extinction (LE) was applied to determine the soot volume fraction. Among the cases of different oxidizer oxygen concentrations (23.5% to 18.5%), the change in soot volume fraction was quantified, and the degree of graphitization of soot particles, i.e., the maturity, were compared. The results show that the peak value of soot volume fraction of the flames increased by 0.73 ppm as the oxygen concentration increased from 21% to 23.5%, and decreased by 1.25 ppm as the oxygen concentration decreased from 21% to 18.5%. When the oxygen concentration decreased from 23.5% to 18.5%, the soot primary particle diameter at the same dimensionless height decreased and then increased, which was attributed to the competition between the changes in the residence time and the growth rate of the soot particles. The quantitative analysis results of the soot nanostructure suggested that reduced oxygen concentration inhibited the graphitization process of carbon lattices and decreased the maturity and oxidation resistance of soot. When the oxygen concentration decreased from 23.5% to 18.5% at the same dimensionless height, the mean fringe length decreased by an average of 0.18 nm, and the mean value of fringe tortuosity and spacing increased by an average of 0.053 and 0.035 nm.
8 April 2024 in Journal of Thermal Analysis and Calorimetry
This paper tries to clarify the respective significance of thermal effects and airflow density on the influence of bag breakup of water droplets in hot airflow. The bag breakup processes of water droplets in the airflow temperature range of 293 K (ρg=1.205 kg/m3) to 493 K (ρg=0.716 kg/m3) were investigated. Meanwhile, room-temperature gas mixtures with corresponding densities were prepared using room-temperature helium blended with room-temperature air to explore the bag breakup processes of water droplets. The results show that although the critical conventional Weber number (Wecon) of spherical droplets for bag breakup varies significantly in both streams, the critical initiation Weber number (Weini) of disk-shaped droplets for bag breakup remains almost consistent. Different deformation processes from Wecon to Weini result in different Wecon. In the gas mixtures with room temperature, the critical Wecon for bag breakup increases from 9.47 to 12.12 as the stream density decreases from 1.205 to 0.716 kg/m3. However, the critical Wecon for bag breakup decreases from 9.47 to 7.80 in the hot airflow at identical airflow density variations.