A large, deep-seated ancient landslide was partially reactivated on 17 June 2020 close to the Aniangzhai village of Danba County in Sichuan Province of Southwest China. It was initiated by undercutting of the toe of this landslide resulting from increased discharge of the Xiaojinchuan River caused by the failure of a landslide dam, which had been created by the debris flow originating from the Meilong valley. As a result, 12 townships in the downstream area were endangered leading to the evacuation of more than 20000 people. This study investigated the Aniangzhai landslide area by optical and radar satellite remote sensing techniques. A horizontal displacement map produced using cross-correlation of high-resolution optical images from Planet shows a maximum horizontal motion of approximately 15 meters for the slope failure between the two acquisitions. The undercutting effects on the toe of the landslide are clearly revealed by exploiting optical data and field surveys, indicating the direct influence of the overflow from the landslide dam and water release from a nearby hydropower station on the toe erosion. Pre-disaster instability analysis using a stack of SAR data from Sentinel-1 between 2014 and 2020 suggests that the Aniangzhai landslide has long been active before the failure, with the largest annual LOS deformation rate more than 50 mm/yr. The 3-year wet period that followed a relative drought year in 2016 resulted in a 14% higher average velocity in 2018–2020, in comparison to the rate in 2014–2017. A detailed analysis of slope surface kinematics in different parts of the landslide indicates that temporal changes in precipitation are mainly correlated with kinematics of motion at the head part of the failure body, where an accelerated creep is observed since spring 2020 before the large failure. Overall, this study provides an example of how full exploitation of optical and radar satellite remote sensing data can be used for a comprehensive analysis of destabilization and reactivation of an ancient landslide in response to a complex cascading event chain in the transition zone between the Qinghai-Tibetan Plateau and the Sichuan Basin.
17 January 2023 in ISPRS Journal of Photogrammetry and Remote Sensing
Using SAR and InSAR technology, artificial corner reflectors (CR) are popular coherent targets for monitoring ground instability with sub-centimeter accuracy in non-urban areas. In this letter, we investigate the performance of a newly designed small dihedral corner reflector for monitoring post-failure creep at the Aniangzhai landslide in Danba County, China. The new double geometry CRs consist of two sets of semi-circular metal plates, each 30-40 cm in radius and perpendicular to each other. Six such CRs are installed for Corner Reflector Interferometric SAR (CR-InSAR) analysis using both TerraSAR-X (TSX) High-resolution Spotlight (HS) data and medium-resolution Sentinel-1 (S1) SAR images. The CRs are first identified in SAR images using a probability model by taking into three factors. These are (1) inverse of amplitude dispersion, (2) intensity increment after the installation, (3) an upper empirical bound derived from the ensemble average of pixel intensities in post-deployment SAR images. Experimental results show that the CRs improve the background intensity in TSX images by around 30 dB, with signal-to-clutter ratio (SCR) exceeding 25 dB. Furthermore, the radar cross-section (RCS) of CRs in both TSX and S1 images remains relatively stable, ranging from 15 dB to 23 dB, making them suitable for CR-InSAR analysis using double-difference phase observations.