Adhesive procedures have changed the way to restore endodontically treated teeth (ETT). It started with the shift from cast post-and-core to fiber post. The original focus on strength also shifted towards failure modes, revealing that catastrophic failures are still a concern when restoring endodontically-treated teeth even with fiber posts. As an alternative, postless approaches have been proposed in order to improve the chances of repair. The goal of this critical review is to present a survey of the current knowledge on adhesive approaches to restore endodontically treated teeth with and without extensive coronal tissue loss. The preservation of tooth structure of endodontically treated teeth is paramount. Partial versus full coverage of ETT, the role of the ferrule, the post type effect on catastrophic failures and postless alternatives as endocrowns and postless build-ups are reviewed. There is a consensus that the remaining tooth structure plays an important role in ETT survival, although the current literature still is contradictory on the influence of post type on root fractures as well as the benefits of avoiding a post or partially restoring a tooth. More clinical studies should be carried out with the modern postless adhesive alternatives to conventional approaches.
6 January 2021 in Journal of Esthetic and Restorative Dentistry
The aim of this study was to investigate the influence of the luting agent on the application of laminate veneers (LVs) in an accelerated fatigue and load-to-failure test after thermo-cyclic aging. Sound maxillary central incisors (N=40) were randomly divided into four groups to receive LVs (Li2Si2O5) that were adhesively bonded: Group CEMF: Adhesive cement (Variolink Esthetic LC), fatigue test; Group CEMLF: Adhesive cement, load-to-failure test; Group COMF: Resin composite (Enamel HFO), fatigue test; Group COMLF: Resin composite, load-to-failure test. The specimens were thermo-mechanically aged (1.2×106 cycles at 1.7Hz/50N, 8000 cycles 5-55°C) and then subjected to either accelerated fatigue (5Hz, 25N increasing after each 500 cycles) or load to failure (1mm/min). Failure types were classified and data analyzed using chi-square, Kaplan Meier survival, Log Rank (Mantel-Cox) and independent-samples t-test. After thermo-mechanical aging, fracture resistance (p<0.000) was higher in the composite groups. Kaplan Meier survival rates showed significant difference (p<0.001) between the composite (mean load: 1165N; mean cycles: 22.595) and the cement groups (mean load: 762.5N; mean cycles: 14.569). The same differences were observed in the load to failure test (cement M=629.4N, SD±212.82 and composite M=927.59N, SD±261.06); t (18)=-2.80, p=0.01. Failure types were observed as fractures and chipping in group CEMF, all other groups were predominantly adhesive failures between the luting agent and the laminate veneer. The delivery of laminate veneers using a direct restorative composite rather than a resin cement resulted in significantly less chipping and fractures, higher fracture strength in both accelerated fatigue and load-to-failure.
1 December 2013 in Journal of Applied Oral Science