We demonstrated an optimization of a picosecond fiber amplifier based on Yb-doped tapered fiber in a spectral range of 1030 nm. Nonlinear effects limiting peak power scaling (stimulated Raman scattering and four-wave mixing) were studied and factors affecting their threshold were established, such as gain, diameter profile along the length of taper, output mode field diameter, and numerical aperture of a pump. By determining the optimal amplification regime and manufacturing advanced tapered fibers, we amplified 13 ps pulses to a record-high peak power of 1 MW at a wavelength of 1029 nm directly at the output of the fiber at an average power of 13.8 W. Four-wave mixing was the limiting factor, and the total fraction of deleterious components in the output spectrum was ~2%. The quality of the output beam was close to being diffraction limited (M2 < 1.2).
The thin MAPbI3 and MA0.15FA0.75Cs0.1PbI3 perovskite films have strong nonlinear absorption with coefficients of 443 ± 20 and 830 ± 50 cm GW–1, respectively, due to two-photon absorption at 1064 nm. The photochemical degradation of perovskite films was observed upon irradiation with femtosecond pulses at 532 nm, and the depth of photodegradation decreased in perovskite films protected with a PMMA polymer layer.
17 October 2019 in Journal of the Optical Society of America B
The nonlinear optical responses of perovskite films CsPbI2Br, MAPbI3 + 1% PVC, MA0.15FA0.75Cs0.1PbI2.85Br0.15, and MA0.15FA0.75Cs0.1PbI3, irradiated by femtosecond laser pulses with wavelengths of 1064 and 532 nm, are investigated using z-scan measurements. Nonlinear absorption is found to occur in perovskite films irradiated at a wavelength of 1064 nm; the nonlinear absorption coefficient in thin films (45 – 65 nm) greatly exceeds that in thick ones (120 – 350 nm): 524 – 928 and 38 – 50 cm GW−1, respectively. It is shown that the nonlinear absorption saturation intensity for perovskite films depends on the pump pulse duration and increases with pulse shortening. It is also established that the nonlinear absorption coefficient of organometallic perovskite films exceeds that of a film of inorganic perovskite CsPbI2Br. Bleaching of film samples during z-scanning at a wavelength of 532 nm is related to the irreversible photochemical degradation of films exposed to intense light. The kinetics of photochemical bleaching of the films is detected at a wavelength of 532 nm.