In the past several decades, the inverted-T bent caps (ITBCs) have been frequently used as an innovative type of bridge superstructure worldwide. In some specimens, the bent caps have to be skewed to meet the landscaping requirements. However, the traditional design of ITBC simply flares the transverse shear reinforcements out in skewed ITBCs, which brings significant inconvenience. In order to reduce the construction cost, an alternative skew arrangement with all the reinforcement arranged in parallel throughout the bent cap is recently adopted by Texas Department of Transportation (TxDOT). To investigate the feasibility of this technique, the shear reinforcement arrangement, as well as three other major parametric variations: shear reinforcement spacing, skew angle, and loading position, are studied regarding their effects on the behavior of skewed ITBCs. A total of 17 numerical models are simulated, among which three specimens are verified and validated by experimental results. The same modeling scheme and material parameters are applied to the remaining specimens. The analytical results indicate that the load–displacement curves of ITBCs are not notably changed by the proposed skew reinforcement arrangement, while the reinforcement spacing affects the ultimate capacity and ductility to a limited extent. The increase of the skew angle significantly affects the performance and failure modes. Meanwhile, a modified practical equation for the edge extension length of skewed ITBCs is proposed based on the parametric analysis of varying loading positions.
11 July 2022 in Structural Control and Health Monitoring
Inverted-T bridge caps (ITBCs) have been widely used in most bridges in Texas in recent years. In some typical cases, the bridge caps are skew when two roads are not aligned in a perpendicular manner. The traditional method of flaring the transverse reinforcement out in skew ITBCs introduces significant complexity in design and during construction. An alternative is to provide skew reinforcing which will substantially reduce the design complexities and construction period. In this paper, three ITBC specimens were subjected to shear action to evaluate and compare the performance of ITBCs with traditional reinforcing with those with skew reinforcing. The three specimens include 0-degree skew, 30-degree skew with traditional reinforcing, and 30-degree skew with skew reinforcing, worthy of verification and quantification as demonstrated in this paper. The physical test results show that the skew reinforcement arrangement does not weaken the bridge cap’s capacity, and the structural performance remains almost the same as that of the traditional arrangement. In addition, the serviceability performance of skew reinforcements is better as compared with traditional reinforcements.
In highway design, inverted-T bridge caps (ITBCs) have been extensively used in the United States. Depending on the project requirements, some ITBCs need to be skewed. In Texas, the traditional method of flaring the transverse reinforcement out is used to design the skewed ITBCs, as stated in the Texas Department of Transportation (TxDOT) Bridge Design Manual. However, this method has significant drawbacks in terms of design and construction. To solve the complexities of the traditional method, the skewed reinforcing method is proposed to TxDOT. In this paper, to enlarge the knowledge of the structural behavior and the economic impact of skew reinforcing in ITBCs, the nonlinear finite-element (FE) simulation and cost–benefit analysis of 96 full-scale skewed ITBC models are performed. The structural and economic performance of the specimens are investigated and compared according to the following design variables: (1) skew angle; (2) transverse reinforcement detailing; (3) amount of the transverse reinforcement; (4) presence of the end reinforcement; (5) size of the diagonal end reinforcement; and (6) the concrete strength. The finite-element analysis shows that skew reinforcing can achieve better structural performance than the traditional method in terms of stiffness, crack width, and the ultimate capacity. Moreover, the skew transverse reinforcement method considerably reduces the design and construction costs.