We have measured the spin injection efficiency and spin lifetime in -GaAs lateral nonlocal spin valves from 20 to 300 K. We observe large () spin valve signals at room temperature and injector currents of , facilitated by fabricating spin valve separations smaller than the spin diffusion length and applying a forward bias to the detector contact. The spin transport parameters are measured by comparing the injector-detector contact separation dependence of the spin valve signal with a numerical model accounting for spin drift and diffusion. The apparent suppression of the spin injection efficiency at the lowest temperatures reflects a breakdown of the ordinary drift-diffusion model in the regime of large spin accumulation. A theoretical calculation of the D'yakonov-Perel' spin lifetime agrees well with the measured -GaAs spin lifetime over the entire temperature range.
We demonstrate controlled growth of face-centered cubic (FCC), monodisperse hard-sphere colloidal crystals by centrifugation at up to 3000g onto FCC (100) templates. Such rapid deposition rates often result in an amorphous sediment. Surprisingly, however, growth onto (100) templates results only in single crystals with few or no extended defects. By contrast, deposition onto flat, (111), or (110) templates causes rapid disordering to an amorphous sediment if the dimensionless flux (particle volume fraction × Peclet number) exceeds a critical value. This crystalline-to-amorphous crossover results from the degeneracy of possible stacking positions for these orientations. No such degeneracy exists for growth onto (100). After growth, extended defects can nucleate and grow only if the crystal exceeds a critical thickness that depends on the lattice misfit with the template spacing. The experimental observations of the density of misfit dislocations are accounted for by the Frank–van der Merwe theory, adapted for the depth-dependent variation of lattice spacing and elastic constants that results from the gravitational pressure.
Point defects in solid-state materials are promising systems in the fields of quantum information, communications, and sensing. Particular to sensing, defects with coherent spin states are used for high-sensitivity room-temperature sensing under ambient conditions. Applications involving magnetic sensing with point defects are mostly dominated by the nitrogen-vacancy center in diamond, which possesses an attractive combination of spin coherence at room temperature as well as spin initialization and read-out. However, spin defects in other materials are explored as alternatives, especially in industrially mature materials, such as silicon carbide. Here, we report on the improved sensitivity of a magnetic sensor system utilizing an ensemble of silicon vacancies in silicon carbide due to isotopic purification of the host crystal. A maximum sensitivity of 4.0 nT/√Hz is reported, representing an order of magnitude improvement from the best previously reported sensitivity. Additional sensing modalities, such as angle-resolved magnetic imaging and highly broadband ac field sensing, are also demonstrated.
For solid-state spin systems, unwanted interactions with surrounding spin baths and inhomogeneity are ubiquitous challenges. In defect spin systems, part of this challenge is that the process of generating the desired defect often involves creating numerous unwanted defects that induce dephasing. Here we show that many of these issues can be alleviated with the silicon vacancy in silicon carbide (), which is a simple defect to produce as it does not require the introduction of impurity atoms into the crystal. Previous measurements of the inhomogeneous dephasing time of silicon-vacancy ensembles have thus far been limited to a few 100 ns due to the nuclear spin bath. We perform isotopic purification to minimize the influence of nuclear spins, leading to an order of magnitude improvement in the at room temperature. Further improvements emerge by suppressing the effects of strain inhomogeneity via an informed choice of basis in the spin quartet. Combining these techniques leads to about a factor 50 improvement in the of the defect ensemble even at high defect densities.