1 February 2019 in Advanced Powder Technology
SMSaeed Zolfaghari Moghaddam
Saeed Zolfaghari Moghaddam
6 October 2023 in Scientific Reports
Greenhouse gases such as CO2 are considered effective materials in global warming due to their high absorptivity. So, lowering atmospheric CO2 is one of the most practical strategies. Utilizing carbon dioxide in chemical processes is an applicable method. In this study, Aspen HYSYS 10 was used to investigate how carbon dioxide can be added to the process of dimethyl carbonate production, and the affective parameters of the process, including temperature, residence time, feed ratio, and recycle ratio, were evaluated. It was observed that the production of DMC grew as temperature rose. The simulation results also revealed that a maximum conversion of roughly 8% was attained in the MeOH/EC. Additionally, boosting the recycle ratio is detrimental, and the impact of temperature and MeOH/EC has been enhanced by increasing the residence time. The interactions of the above parameters have been studied by Design Expert 12. The optimum value of effective parameters for the production of dimethyl carbonate has been obtained as follows: temperature of 164.7° C, recycle ratio of 0.2, residence time of 139.45 min, and feed ratio of 5.9%, leading to the conversion of 70%.
1 September 2019 in Journal of the Taiwan Institute of Chemical Engineers
FVFarzin H. Vazifehshenas
2 December 2018 in Journal of Sulfur Chemistry
ADAhmad Taghizadeh Damanabi
Ahmad Taghizadeh Damanabi
In this study, the decomposition of hydrogen sulfide and reforming of hydrocarbons were employed for producing hydrogen. Thermolysis of H2S in the platinum-based catalytic reactor led to the production of hydrogen and sulfur. It is observed that the presence of catalyst increased the conversion of H2S decomposition up to 99.6%. Also, the hydrocarbon content of acid gas stream (CH4) was converted to syngas, especially hydrogen in a catalytic reforming process. The produced hydrogen was separated using a Pd/Ag membrane. The simulation results showed that hydrogen production in a sulfur recovery unit provided a green source of energy by incinerating gasses. By hydrogen production during the process, the molar flow rate of incinerating gasses reduced from 2555 to 621 Kmol/h. Moreover, the hazardous sulfur compounds of the stack were removed, while hydrogen was produced by 256 Kmol/hr.
3 July 2025 in Biomass and Bioenergy
23 April 2023 in Clean Technologies and Environmental Policy