Active fault detection has an important significance for seismic disaster prevention and mitigation in urban areas. The high-density station arrays have the potential to provide a microtremor survey solution for shallow seismic investigations. However, the resolution limitation of the nodal seismometer and small-scale lateral velocity being inhomogeneous hinder their application in near-surface active fault exploration. Distributed acoustic sensing (DAS) has been developed rapidly in the past few years; it takes an optical fiber as the sensing medium and signal transmission medium, which can continuously detect vibration over long distances with high spatial resolution and low cost. This paper tried to address the issue of near-surface active fault exploration by using DAS. We selected a normal fault in the southern Datong basin, a graben basin in the Shanxi rift system in north China, to carry out the research. Microtremor surveys across the possible range of the active fault were conducted using DAS and nodal seismometers, so as to obtain a shallow shear wave velocity model. Meanwhile, we applied a Brillouin optical time domain reflectometer (BOTDR) and distributed temperature sensing (DTS) to monitor the real-time fluctuation of ground temperature and strain. Our results show that the resolution of the deep structures of the fault via the microtremor survey based on DAS is lower than that via the seismic reflection; whereas, their fault location is consistent, and the near-surface structure of the fault can be traced in the DAS results. In addition, both the BOTDR and DTS results indicate an apparent consistent change in ground temperature and strain across the fault determined by the DAS result, and the combination of surface monitoring and underground exploration will help to accurately avoid active faults and seismic potential assessment in urban areas.

Until the Mw 6.6 Luding earthquake ruptured the Moxi section of the Xianshuihe fault (XSHF) on 5 September 2022, the region had not experienced an Mw >6 earthquake since instrumental records began. We used Global Positioning System (GPS) and Sentinel-1 interferometric synthetic aperture radar (InSAR) observations to image the coseismic deformation and constrain the location and geometry of the seismogenic fault using a Bayesian method We then present a distributed slip model of the 2022 Mw6.6 Luding earthquake, a left-lateral strike-slip earthquake that occurred on the Moxi section of the Xianshuihe fault in the southwest Sichuan basin, China. Two tracks (T26 and T135) of the InSAR data captured a part of the coseismic surface deformation with the line-of-sight displacements range from ∼−0.16 m to ~0.14 m in the ascending track and from ~−0.12 m to ~0.10 m in the descending track. The inverted best-fitting fault model shows a pure sinistral strike-slip motion on a west-dipping fault plane with a strike of 164.3°. We adopt a variational Bayesian approach and account for the uncertainties in the fault geometry to retrieve the distributed slip model. The inverted result shows that the maximum slip of ~1.82 m occurred at a depth of 5.3 km, with the major slip concentrated within depths ranging from 0.9–11 km. The InSAR-determined moment is 1.3 × 10¹⁹ Nm, with a shear modulus of 30 GPa, equivalent to Mw 6.7. The published coseismic slip models of the 2022 Luding earthquake show apparent differences despite the use of similar geodetic or seismic observations. These variations underscore the uncertainty associated with routinely performed source inversions and their interpretations for the underlying fault model.

Preliminary tunnel surveys are essential for identifying geological hazards such as aquifers, faults, and karstic zones. While first-arrival tomography is effective for imaging shallow anomalies, traditional seismic sources face significant limitations in forested mountainous regions due to mobility, cost, and environmental impact. To address this, we deployed a seismic source delivered by an unmanned aerial vehicle (UAV) for a highway tunnel survey in Lijiang, China. The UAV system, paired with nodal geophones, enabled rapid, low-impact, and high-resolution data acquisition in rugged terrain. To enhance the weak far-offset refractions affected by near-surface attenuation, we applied supervirtual refraction interferometry (SVI), which significantly improved the signal-to-noise ratio and expanded the usable first-arrival dataset. The combined use of UAV excitation and SVI processing produced a high-precision P-wave velocity model through traveltime tomography, aligned well with borehole data. This model revealed the spatial distribution of weathered zones and bedrock interfaces, and allowed us to infer potential fracture zones. The results offer critical guidance for tunnel alignment and hazard mitigation in complex geological settings.