Alakesh Manna

Dr. Alakesh Manna

Auto-generated profile, based on publicly available information

Dr. Alakesh Manna


Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2004 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
AMAlakesh Manna
Alakesh Manna
BBB. Bhattacharayya
B. Bhattacharayya

13 April 2005 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
AMA. Manna
A. Manna
BBB. Bhattacharyya
B. Bhattacharyya

7 July 2021 in Arabian Journal for Science and Engineering
Verified
Journal Article
Open access
PDF file
AKAmresh Kumar
Amresh Kumar
NGNeelkanth Grover
Neelkanth Grover
AMAlakesh Manna
Alakesh Manna
Raman KumarRaman Kumar
Raman Kumar
JCJasgurpreet Singh Chohan
Jasgurpreet Singh Chohan
Catalin PruncuCatalin Pruncu
Catalin Pruncu
Aluminum hybrid composites have the potential to satisfy emerging demands of lightweight materials with enhanced mechanical properties and lower manufacturing costs. There is an inclusion of reinforcing materials with variable concentrations for the preparation of hybrid metal matrix composites to attain customized properties. Hence, it is obligatory to investigate the impact of different machining conditions for the selection of optimum parameter settings for aluminum-based hybrid metal matrix composite material. The present study aims to identify the optimum machining parameters during wire electrical discharge machining of samples prepared with graphite, ferrous oxide, and silicon carbide. In the present research work, five different process parameters and three response parameters such as material removal rate, surface roughness, and spark Gap are considered for process optimization. Energy-dispersive spectroscopy and scanning electron microscopy analysis reported the manifestation of the recast layer. Analytical hierarchy process and genetic algorithm have been successfully implemented to identify the best machining conditions for hybrid composites.

10 March 2010 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
HMHarlal Singh Mali
Harlal Singh Mali
AMAlakesh Manna
Alakesh Manna

12 April 2012 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
AMAlakesh Manna
Alakesh Manna
VNVivek Narang
Vivek Narang

21 January 2011 in Journal of Composite Materials
Verified
Journal Article
Closed access
AMA. Manna
A. Manna
HBH.S. Bains
H.S. Bains
PMP.B. Mahapatra
P.B. Mahapatra
In this study, aluminum (Al-6070)/alumina (Al2O3) and Al-6070/graphite (Gr)-reinforced metal—matrix composites (MMCs) are fabricated by melt-stirring technique. The MMC bars and plates are prepared with varying the reinforced particles volume fraction ranging from 5% to 15%. The average reinforced particle sizes of alumina (Al 2O3) and graphite (Grp) are 23 and 53 μm, respectively. The stirring process was carried out at 200 rpm rotating speed by graphite impeller for 15 min. The microstructure and mechanical properties are investigated on prepared MMCs. It was observed that the hardness of the composite is increased with the increase in reinforced particle volume fraction. Both tensile strength and impact strength are decreased with increase in reinforced volume fraction. The prepared composite plates are welded by gas welding with Al—Si-base filler metal. Rockwell hardness test was conducted and the test result was presented for un-welded and welded zones.