Mohammad Raja Ismail AL-SOEIDAT

Dr. Mohammad Raja Ismail AL-SOEIDAT

ELectrical Engineering, Al-Hussein Bin Talal University, Ma'an, Jordan
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 September 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
HAHamzeh Aljarajreh
Hamzeh Aljarajreh
HKHabes ali ahmad Khawaldeh
Habes ali ahmad Khawaldeh
DLDylan Lu
Dylan Lu
Jian ZhuJian Zhu
Jian Zhu
In this paper, a new non-isolated three-port DCDC converter to integrate a battery storage with a photovoltaic module is proposed for off-grid solar power applications. The proposed converter can be used to integrate the PV module with a backup battery to minimize the impacts of renewable energy intermittency and unpredictable load demand. The proposed converter is reconfigurable and able to operate as a conventional boost converter, a buck-boost converter or a forward converter in different modes to support several power flow combinations and achieve power conditioning and regulation among the PV module, battery and output port simultaneously. Nevertheless, the power stage only consists of two switches, one coupled inductor, one diode and two capacitors. High voltage conversion ratio is achieved by using a coupled inductor and by combining the photovoltaic module and the battery in series. Experimental results of the proposed converter operating in the steady-state and during transitions between different modes are reported.

16 August 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
DLDylan Lu
Dylan Lu
Jian ZhuJian Zhu
Jian Zhu
In this brief, an analog, bipolar junction transistor (BJT)-tuned voltage reference maximum power point tracking (MPPT) method for photovoltaic modules is proposed. The conventional fixed voltage reference method is the simplest method for tracking, but it does not obtain good MPPT efficiency because the maximum power point (MPP) voltage changes at different insolation levels. In reality, an approximately linear slope is formed when connecting the MPPs measured from the highest insolation level to the lowest. Utilizing this characteristic, a BJT, which has a similar electrical property, is used to implement a variable voltage reference that improves the accuracy of the MPP voltage when the insolation changes. The proposed circuit is simple and easy to implement, and it can track the MPP very quickly without the need for a digital controller or PID controller. Hence, the circuits cost and complexity are reduced. Experimental results are given to verify the feasibility of the proposed MPPT method.

1 November 2018
Verified
Conference Paper
Closed access
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
HKHabes Khawaldeh
Habes Khawaldeh
HAHamzeh Aljarajreh
Hamzeh Aljarajreh
DLDylan Lu
Dylan Lu
In this paper, a new non-isolated three-port DC-DC converter (NITPC) to integrate a battery storage with a PV module is proposed. The intermittency of renewable energy and the unpredictable load demand are eliminated by firming a backup battery with the PV module to supply extra power when it is required. The proposed converter is reconfigurable and able to operate as a conventional boost converter, a buck-boost converter or a forward converter in different modes to support several power flow combinations and achieve power conditioning and regulation among the PV module, battery and an output port simultaneously. Nevertheless, the converter only consists of two switches, one coupled inductor, one diode and two capacitors. Thus, the system size and number of components are reduced compared with the traditional DC-DC converters. High output regulated voltage is achieved by using a coupled inductor and by combining the PV module and the battery in series. Simulation and experiment are carried out to verify the proposed circuit.

24 November 2016
Verified
Conference Paper
Closed access
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
ACAlexis Cembrano
Alexis Cembrano
DLDylan Lu
Dylan Lu
For photovoltaic (PV) systems, a key area which can affect the amount of energy harvested is the effectiveness of the Maximum Power Point Tracking (MPPT) algorithm, which dynamically locates the operating point for maximum power output. Currently, there are many MPPT algorithms proposed and in use, however, they are not without problems. For example, algorithms such as the Fractional Open Circuit method are simple and effective, but their accuracy is poor. Other algorithms such as the Perturb & Observe (P&O) approach, although more accurate, will cause oscillations around the maximum power point. It is perceived that the use of two MPPT algorithms in tandem will help to overcome the drawbacks of individual MPPT algorithms used in isolation. This paper proposes two new versions of Hybrid MPPT algorithm; one being a combination of the Fractional Open Circuit Voltage and P&O methods, and the other a combination of the Power Increment and P&O techniques. Experimental results are reported to evaluate and compare the performance of the algorithms.

21 November 2019 in IET Renewable Power Generation
Verified
Journal Article
Open access
PDF file
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
TCTian Cheng
Tian Cheng
DLDylan Lu
Dylan Lu
VAVassilios G. Agelidis
Vassilios G. Agelidis
Solar cell power performance is greatly affected by two critical factors ageing and crack. In order to mitigate their negative effects on the solar system, these cells are to be substituted by new cells, thus, replacing the panels. This study presents an active crack detection method that detects the cracked cells within a solar string by using AC parameter characterisation without a need to have a physical inspection. The mathematical module of the solar cell shows that it constitutes of series and parallel resistors in addition to a parallel capacitor and that their values change by ageing and crack. In addition to studying the effects of the crack on the solar cell, it is verified by the experiment that the solar cells behave as a capacitive circuit, and their capacitance increases when the cell gets cracked, getting higher as the crack becomes more serious. The experiment is extended to investigate the effect of series and parallel PV strings, which are affected by cracked and partially shaded cells to evaluate their criticality levels. By monitoring the AC parameter of the solar cell and the change of the capacitance, it is easy to detect the crack when it occurs.

30 September 2025 in World Electric Vehicle Journal
Verified
Journal Article
Open access
PDF file
ASAHMAD SALAH
AHMAD SALAH
MSMohammad Shalby
Mohammad Shalby
Mohammad Raja Ismail AL-SOEIDATMohammad Raja Ismail AL-SOEIDAT
Mohammad Raja Ismail AL-SOEIDAT
FAFadi Alhomaidat
Fadi Alhomaidat
Jordan Vision prioritizes the utilization of domestic resources, particularly renewable energy. The transportation sector, responsible for 49% of national energy consumption, remains central to this transition and accounts for around 28% of total greenhouse gas emissions. Electric vehicles (EVs) offer a promising solution to reduce waste and pollution, but they also pose challenges for grid stability and charging infrastructure development. This study addresses a critical gap in the planning of renewable-powered EV charging stations along Jordanian highways, where EV infrastructure is still limited and underdeveloped, by optimizing the design of a hybrid energy charging station using HOMER Grid (v1.9.2) Software. Region-specific constraints and multiple operational scenarios, including rooftop PV integration, are assessed to balance cost, performance, and reliability. This study also investigates suitable locations for charging stations along the Sahrawi Highway in Jordan. The proposed station, powered by a hybrid system of 53% wind and 29% solar energy, is projected to generate 1.466 million kWh annually at USD 0.0375/kWh, reducing CO2 emissions by approximately 446 tonnes annually. The findings highlight the potential of hybrid systems to increase renewable energy penetration, support national sustainability targets, and offer viable investment opportunities for policymakers and the private sector in Jordan.