Giovanni Mantovani

Mr. Giovanni Mantovani

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 October 2025 in Sensors
Verified
Journal Article
Open access
PDF file
ASAashish Shaju
Aashish Shaju
NKNikhil Kumar
Nikhil Kumar
GMGiovanni Mantovani
Giovanni Mantovani
SSSteve Southward
Steve Southward
Mehdi AhmadianMehdi Ahmadian
Mehdi Ahmadian
Undetected cracks in railroad wheels pose significant safety and economic risks, while current inspection methods are limited by cost, coverage, or contact requirements. This study explores the use of passive, air-coupled ultrasonic acoustic (UA) sensors for detecting wheel damage on stationary or moving wheels. Two controlled datasets of wheelsets, one with clear damage and another with early, service-induced defects, were tested using hammer impacts. An automated system identified high-energy bursts and extracted features in both time and frequency domains, such as decay rate, spectral centroid, and entropy. The results demonstrate the effectiveness of UAE (ultrasonic acoustic emission) techniques through Kernel Density Estimation (KDE) visualization, hypothesis testing with effect sizes, and Receiver Operating Characteristic (ROC) analysis. The decay rate consistently proved to be the most effective discriminator, achieving near-perfect classification of severely damaged wheels and maintaining meaningful separation for early defects. Spectral features provided additional information but were less decisive. The frequency spectrum characteristics were effective across both axial and radial sensor orientations, with ultrasonic frequencies (20–80 kHz) offering higher spectral fidelity than sonic frequencies (1–20 kHz). This work establishes a validated “ground-truth” signature essential for developing a practical wayside detection system. The findings guide a targeted engineering approach to physically isolate this known signature from ambient noise and develop advanced models for reliable in-motion detection.

20 August 2025 in Designs
Verified
Journal Article
Open access
PDF file
GMGiovanni Mantovani
Giovanni Mantovani
NKNikhil Kumar
Nikhil Kumar
Mehdi AhmadianMehdi Ahmadian
Mehdi Ahmadian
This study presents a novel design for emulating wheelset curving dynamics by implementing a laterally constrained wheelset and two independently powered rollers. The new configuration extends the test capability of the existing Virginia Tech-Federal Railroad Administration (VT-FRA) roller rig from a single wheel to a wheelset (i.e., two wheels). The redesigned rig is intended for evaluating both the tangent track and curving dynamics of a wheelset on a railcar. Test data from earlier experiments with a single wheelset is analyzed to assess the control system’s ability to maintain the commanded roller speed. This evaluation determines whether the new system can accurately emulate curves. The study develops correction factors to account for the dissimilar contact patch sizes and longitudinal creep forces resulting from the dissimilar roller diameters. A novel force measurement method is proposed to resolve the creep forces at each contact patch independently. An assessment of the existing VT-FRA roller rig data indicates a maximum roller speed deviation of 0.37% from actual values, which is deemed to be within the intended accuracy for future tests with the redesigned rig. An analysis of the force measurements by a load platform demonstrates the feasibility of accurately determining the wheel–rail contact forces for the new design rig, identical to the original design. Despite the numerous challenges in integrating a new wheel and roller into the existing VT-FRA roller rig, the study demonstrates that such a redesign can be achieved within the space and kinematic constraints, while maintaining the intended measurement accuracy.