Heng Dong

Dr. Heng Dong


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 May 2022 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
TZTing Zhang
Ting Zhang
LSLu Sun
Lu Sun
XSXiaohong Sun
Xiaohong Sun
Heng DongHeng Dong
Heng Dong
HYHan Yu
Han Yu
HYHongbing Yu
Hongbing Yu

29 October 2014 in RSC Advances
Verified
Journal Article
Closed access
PDF file
QWQinian Wang
Qinian Wang
Heng DongHeng Dong
Heng Dong
HYHongbing Yu
Hongbing Yu
Current gas diffusion electrodes (GDEs) for electrochemical reduction of carbon dioxide to formic acid (ERCF) suffer from poor catalyst utilization or high cost. In this work, we developed a novel Sn GDE (SGDE) consisting of a PTFE-bound gas diffusion layer produced using the rolling-press method and a Nafion-bound catalyst layer synthesised by spraying. The influence of Sn loading, Nafion fraction and electrolytic potential was studied. The results showed that increasing the Sn loading and Nafion fraction in an appropriate range both led to an improvement in ERCF via the increase in the total area of the gas–liquid–solid three phase interface. The shift of the electrolytic potential in the negative direction accelerated ERCF, but shifting too far caused the occurrence of side reactions. The highest Faraday efficiency (72.99 ± 1.91%) and current density (13.45 ± 0.72 mA cm−2) for ERCF were obtained at −1.8 V vs. Ag/AgCl with the SGDE when the Sn loading and Nafion fraction were 5 mg cm−2 and 50 wt%, respectively. This Faraday efficiency is one of the highest values for Sn GDEs under ambient pressure. Moreover, the fabrication cost of the SGDE is low (ca. 80 % m−2). This work indicates the great potential of the SGDE for ERCF in large scale applications.

7 January 2015 in RSC Advances
Verified
Journal Article
Closed access
PDF file
QWQinian Wang
Qinian Wang
Heng DongHeng Dong
Heng Dong
HYHongbing Yu
Hongbing Yu
HYHan Yu
Han Yu
MLMinghui Liu
Minghui Liu
Electrochemical reduction of CO2 to formic acid (ERCF) is mainly hindered by CO2 mass transfer and high energy consumption. This work developed a two-layer rolled Sn-loaded gas diffusion electrode (SGDE), consisting of a gas diffusion layer and a Sn-loaded brass mesh to improve ERCF in a microbial electrolysis cell (MEC). The morphology and chemical composition of the SGDE were characterized by scanning electron microscopy, X-ray diffraction, energy dispersive X-ray spectroscopy and X-ray photoelectron spectroscopy. The electrochemical behavior of the SGDE for ERCF was assessed by cyclic voltammetry and electrochemical impedance spectroscopy. The Faraday efficiency and production yield of formic acid were measured in order to evaluate ERCF. The electrochemical measurements exhibited the advantages of the SGDE, including higher ERCF current and lower charge transfer resistance, owing to the increase in the working concentration of CO2 in the vicinity of the electrocatalytically active sites. The use of the SGDE in MEC improved Faraday efficiency and production yield of formic acid by 36.1% and 30.6%, respectively. Whereas the energy consumption for ERCF was reduced by approximately 67.2–73.6%.

23 June 2022 in Science China Materials
Verified
Journal Article
Closed access
PDF file
YCYanhui Chu
Yanhui Chu
RYRenwang Yu
Renwang Yu
GHGang He
Gang He
TZTing Zhang
Ting Zhang
Heng DongHeng Dong
Heng Dong
JLJiangtao Li
Jiangtao Li

20 October 2017 in Scientific Reports
Verified
Journal Article
Open access
PDF file
QWQinian Wang
Qinian Wang
XWXinqi Wang
Xinqi Wang
CWChao Wu
Chao Wu
Yuanyuan ChengYuanyuan Cheng
Yuanyuan Cheng
QSQingye Sun
Qingye Sun
HYHongbing Yu
Hongbing Yu
Electroreduction of CO2 to formic acid (ERCF) based on gas diffusion electrodes (GDEs) has been considered as a promising method to convert CO2 into value-added chemicals. However, current GDEs for ERCF suffer from low efficiency of electron transfer. In this work, a novel Sn-based gas diffusion electrode (ESGDE) is prepared by electrodepositing Sn on Nafion-bonded carbon black as catalyst layer to enhance electron transfer and thus the efficiency of ERCF. The highest Faraday efficiency (73.01 ± 3.42%), current density (34.21 ± 1.14 mA cm−2) and production rate (1772.81 ± 59.08 μmol m−2 s−1) of formic acid are obtained by using the ESGDE with electrodeposition time of 90 s in 0.5 M KHCO3 solution, which are one of the highest values obtained from Sn-based gas diffusion electrodes under similar conditions. The notable efficiency of ERCF achieved here should be attributed to the enhancement in the reactants transfer as well as the three-dimensional reaction zone. This work will be helpful for the industrial application of GDEs in EFCF.

28 July 2023 in Science China Materials
Verified
Journal Article
Closed access
PDF file
RYRenwang Yu
Renwang Yu
YLYiwen Liu
Yiwen Liu
XSXiaohong Sun
Xiaohong Sun
GHGang He
Gang He
Heng DongHeng Dong
Heng Dong
YCYanhui Chu
Yanhui Chu