Beza Negash Getu

Dr. Beza Negash Getu

orcid

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 May 2005 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
JAJ.B. Andersen
J.B. Andersen
In this paper, we suggest a multi-input multi-output (MIMO) cube antenna to be used in a wide angular spread environment like an indoor channel. Both space and polarization diversity has been used to constitute the MIMO cube where all the 12 edges consist of electrical dipole antennas. There exist 12 parallel orthogonal transmission links, also called eigenmodes. For a half-wavelength dipole, nine of the eigenmodes have a mean gain higher than the conventional single-input single-output (SISO) system; the highest mean gain is about 8.5 dB/cube, and the theoretical capacity is about 62.5 b/s/Hz for a signal-to-noise ratio (SNR) of 20 dB. The number of essentially active eigenmodes, which is about 11 for a side length of /spl lambda//2, reduces to six for a very compact cube with a side length of /spl lambda//20. With the latter side length, the theoretical capacity is about 34 b/s/Hz. The compact MIMO system promises to give high capacity in a rich scattering environment and may be used for high data rate communications like wireless local area network systems.

1 December 2016
Verified
Conference Paper
Closed access
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
HAHussein Attia
Hussein Attia
In this paper, we investigate the design of a water level sensor device that is able to detect and control the level of water in a certain water tank or a similar water storage system. The system firstly senses the amount of water available in the tank by the level detector part and then adjusts the state of the water pump in accordance to the water level information. This electronic design achieves automation through sequential logic implemented using a flip flop. A seven segment display and a relay-based motor pump driving circuit are part of this integrated design. The water pump automatically turns on and starts filling the tank when the water level is empty or level ONE and turned-off and stop filling the tank when water level reaches maximum-level NINE; furthermore, the water pump will remain in its standstill state from level EIGHT down to TWO when the level is decreasing due to water consumption.

25 June 2003
Verified
Conference Paper
Closed access
JAJ.B. Andersen
J.B. Andersen
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
A compact MIMO antenna is suggested by combining polarization diversity and space diversity into one arrangement consisting of a cube where all 12 edges consist of an electrical dipole. The antenna should be useful in an indoor environment with waves arriving from many directions with arbitrary polarizations. The highest gain values are around 8.5 dB per cube and the theoretical capacity is 47 b/s/Hz for a basic SNR of 20 dB. The number of active channels is 12 for a side length of half-a-wavelength, but reduces to 6 for a very compact antenna. Even for less ideal conditions like only horizontal propagation, or lack of cross polarization, the capacity attains considerable values.

1 October 2005 in Wireless Personal Communications
Verified
Journal Article
Closed access
PDF file
AHAndreas A. Hutter
Andreas A. Hutter
SMSelim Mekrazi
Selim Mekrazi
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
FPFanny Platbrood
Fanny Platbrood

1 September 2015
Verified
Conference Paper
Closed access
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
HAHussein Attia
Hussein Attia
In this paper, we investigate the design and simulation of an electronic system for automatic controlling of water pumps that are used for agricultural fields or plant watering based on the level of soil moisture sensing. The detected signal from the soil moisture sensor is processed by a conditional comparator circuit corresponding to different levels of actual soil moisture content. A logic circuit follows the conditional circuit with its output signals used to activate a system of relays that control the power circuit of the motors used for water pumping. The speed of the motor is varied according to the level of the soil moisture content; the motor is OFF during maximum wet and is running with HIGH speed during dry soil conditions respectively. The duration of water pumping is controlled by a timer circuit where the timer can be designed according to the desired watering time. The different stages of the overall electronic system are simulated and tested using NI MULTISM simulation software. The technique is useful to save human-power, enhances crop or plant productivity, saves water and provides proper water management to ensure efficient and viable farming industry especially in those places that receive less rain or mostly dry areas.

5 August 2015 in Research Journal of Applied Sciences, Engineering and Technology
Verified
Journal Article
Open access
Beza Negash GetuBeza Negash Getu
Beza Negash Getu
HAHussein Attia
Hussein Attia
In this study, we investigate the design and simulation of an electronic system for remote controlling the level of light intensity of an electrical lighting system used for a certain desired application. The remote controlling is done using the keypad of any Dual Tone Multi Frequency (DTMF) based telephone handset. A DTMF tone command sent from a transmitting fixed or mobile phone terminal will be used to activate a system of relays that control the required level of light intensity. An appropriate active bandpass filters are designed for recognition of the DTMF tones of the transmitted digit. The bandpass filters and the additional subsequent stages of the overall electronic system are simulated and tested using MULTISM. Light intensity controlling is useful to avoid unnecessary electrical power wastage and the remote controlling eliminates the physical presence of a person for adjusting the required level of lighting at the desired location.