The aim of this paper is to give some recommendation for the design of main-spring and shock absorber of motor vehicle suspensions. Starting from a 2DoF model, the suspension parameters are transferred on the real vehicle on the base of planar schemes for the linkage. For the coil spring, the equations that must be fulfilled simultaneously permit to calculate three geometrical parameters. The indications presented for the shock absorber permit to obtain the damping coefficients in the compression and rebound strokes and to calculate the power dissipated during the vehicle oscillatory movement.
23 October 2017 in IOP Conference Series: Materials Science and Engineering
To analyze the working possibilities of power-split infinitely variable transmissions (IVTs) it is necessary to follow a systematic approach. The method proposed in this paper consists of generating a block diagram of the transmission and then, based on this diagram, to derive the kinematics and dynamics equations of the transmission. For an actual numerical case, the derived equations are used to find characteristic values of the transmission components (gear and chain drives, planetary units) necessary to calculate the speed ratios, the speeds, torques and powers acting on the shafts and coupling (control) elements, and even to estimate the overall efficiency of the transmission.
Slip angle is the difference between the direction a vehicle is travelling and the longitudinal plane of the vehicle body. Knowing vehicle sideslip angle accurately is critical for active safety systems such as Electronic Stability Program (ESP). Vehicle sideslip angle can be measured using optical speed sensors, inertial sensors and/or dual-antenna GPS receivers. These systems are expensive and their use is limited for many users. The goal of this paper is to analyze the possibility to estimate the vehicle sideslip angle, in real-time, by using two low-cost single-antenna GPS receivers.