Magnetoresistance and efficiency measurements of indium tin oxide/-diphenyl- bis(3-methylphenyl)-(-biphenyl)- diamine/aluminum tris(8-hydroxyquinoline)/cathode organic light-emitting diode structures have been made as a function of magnetic field and cathode type. It has been found that magnetoresistance occurs only when there is light emission from the devices, which suggests that the magnetoresistance is related to exciton formation. Comparison of the effects of applied field on device efficiency and magnetoresistance shows that the magnetoresistance cannot be due to the recombination current. We suggest that the effect may be due to trapping of charge carriers at triplet excitons within the device.
The magnetoresistance (MR) of organic spin valves containing the spacer layer regioregular poly(3-hexylthiophene) (RR-P3HT), which is a conjugated polymer, has been studied at room temperature. Investigations have been made of the influence of the thickness of organic spacer layer on the magnetoresistance of spin valves. It was determined that the MR decreased as the layer thickness increased, consistent with the spin coherence length in this material. It has been observed at room temperature that there is the co-occurrence of two magnetoresistance effects, the spin-valve magnetoresistance, and anisotropic magnetoresistance in the magnetic electrodes.
1 September 2009 in Journal of Magnetism and Magnetic Materials
Fe-based amorphous materials offer new opportunities for magnetic sensors, actuators, and magnetostrictive transducers due to their high saturation magnetostriction (λs = 20–40 ppm) and low coercive field compared with polycrystalline Fe-based alloys, which have high magnetostriction but large coercive fields and Co-based amorphous alloys with small magnetostriction (λs = −3 to −5 ppm). Additive layer manufacturing (ALM) offers a new fabrication technique for more complex net-shaping designs. This paper reviews the two different ALM techniques that have been used to fabricate Fe-based amorphous magnetic materials, including the structural and magnetic properties. Selective laser melting (SLM)—a powder-bed fusion technique—and laser-engineered net shaping (LENS)—a directed energy deposition method—have both been utilised to fabricate amorphous alloys, owing to their high availability and low cost within the literature. Two different scanning strategies have been introduced by using the SLM technique. The first strategy is a double-scanning strategy, which gives rise to maximum relative density of 96% and corresponding magnetic saturation of 1.22 T. It also improved the glassy phase content by an order of magnitude of 47%, as well as improving magnetic properties (decreasing coercivity to 1591.5 A/m and increasing magnetic permeability to around 100 at 100 Hz). The second is a novel scanning strategy, which involves two-step melting: preliminary laser melting and short pulse amorphisation. This increased the amorphous phase fraction to a value of up to 89.6%, and relative density up to 94.1%, and lowered coercivity to 238 A/m. On the other hand, the LENS technique has not been utilised as much as SLM in the production of amorphous alloys owing to its lower geometric accuracy (0.25 mm) and lower surface quality, despite its benefits such as providing superior mechanical properties, controlled composition and microstructure. As a result, it has been commonly used for large parts with low complexity and for repairing them, limiting the production of amorphous alloys because of the size limitation. This paper provides a comprehensive review of these techniques for Fe-based amorphous magnetic materials.