Out of 2 TW_e of coal power plant capacity in operation globally today, more than half is less than 14 years old. Climate policy related to limiting CO₂-emissions makes the longer-term operation of these plants untenable. In this study, we assess the spectrum of available options for the future of both equipment and jobs in the coal power sector by assessing the full scope of “retrofit decarbonization” options. Retrofit decarbonization is an umbrella term that includes adding carbon capture, fuel conversion, and the replacement of coal boilers with new low-carbon energy sources, in each case re-using as much of the existing equipment as economically practicable while reducing or eliminating emissions. This article explores this idea using the Polish coal power fleet as a case study. Retrofit decarbonization in Poland was shown to be most attractive using high-temperature small modular nuclear reactors (SMRs) to replace coal boilers, which can lower upfront capital costs by ~28–35% and levelized cost of electricity by 9–28% compared to a greenfield installation. If retrofit decarbonization is implemented globally by the late 2020s, up to 200 billion tons of otherwise-committed CO₂-emissions could be avoided.

The housing sector, especially with respect to energy generation to provide heating and domestic hot water, has been identified, after transport, as contributing the most to air pollution and the occurrence of low emissions in Poland. In particular, this applies to areas where there is a lack of heating and gas networks. This paper presents the results of calculations relating to the emission of atmospheric pollutants (TSP—total suspended particles as particulate matter PM10 and PM2.5, SO_x—sulphur dioxide, NO_x—nitrogen dioxide, CO—carbon monoxide) from individual sources of heat. The fact that a commune that does not have the network infrastructure, noted above, was taken into consideration, and the structure of heat generation was estimated on the basis of coal, fuel oil and biomass. The analysis was carried out taking into account the variable heat generation structure in households depending on the fuels used, including the heating values of fuels and the efficiency of heating devices. Based on the calculations carried out, an ecological effect was obtained by assuming the replacement of heat sources by devices with higher efficiency and also by considering the possibility of using heat pumps as a zero-emission solution in the households. This article attempts to answer the question posed by municipal authorities on how to limit the negative impact on the environment of individual heating devices in order to achieve sustainable development, including the specific conditions resulting from limited infrastructural opportunities.

The paper presents results of geothermal projects carried out in the last 23 years by the interdisciplinary research team at the AGH University of Science and Technology, in cooperation with numerous scientific institutions, published in the form of geothermal atlases in different parts of Poland. For many years, the Department of Fossil Fuels at the Faculty of Geology, Geophysics and Environmental Protection, AGH University of Science and Technology, has conducted the fundamental research and implementation work, aiming at the selection of optimum areas for utilization of geothermal waters and energy. Over the years, a methodology of estimation of geothermal resources with use of advanced techniques and numerical modeling has been developed. Recapitulation of the studies of the occurrence and utilization of geothermal waters and energy within geological units of the Polish Lowlands, Carpathians and Carpathian Foredeep has been reflected in seven Atlases. The Atlases represent a result of interdisciplinary, constructive cooperation of specialists from various, often remote fields of knowledge, fundamental and technological in nature, including: geologists, geophysicists, hydrogeologists, geochemists, drilling engineers, heat engineers, and many other specialists. The Atlases enable the selection of the most promising areas for utilization of geothermal waters and energy in Poland. The best geothermal conditions are predicted in the Polish Lowlands and Podhale region although in many areas of the Carpathians and the Carpathian Foredeep favorable geothermal conditions also occur.

Rising fuel prices, changes in energy markets, and concern for the environment make it necessary to develop new solutions and technologies. The development of new technologies brings with it the need to take risks associated with unpredictable consequences, technological immaturity, and other issues. However, without these elements, technological development is not possible. In this study, installations related to two different technologies—Enhanced Geothermal System (EGS) and Carbon Capture, Utilization, and Storage (CCUS)—are reviewed. An Enhanced Geothermal System is a technology for exploiting the energy stored in hot dry rocks. Carbon Capture, Utilization, and Storage is an important technology for reducing CO₂ emissions. The combination of these two technologies in CO₂–EGS systems can bring significant environmental benefits. This paper reviews the most important CCUS and EGS systems in the world to form a baseline for similar, future technology investment in Poland.