Shahid Iqbal

Dr. Shahid Iqbal

Sarhad University of science and information technology

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 September 2024 in Scientific Reports
Verified
Journal Article
Open access
PDF file
CYChen Yaqin
Chen Yaqin
SHSaud Ul Haq
Saud Ul Haq
Shahid IqbalShahid Iqbal
Shahid Iqbal
IKInamullah Khan
Inamullah Khan
SRShah Room
Shah Room
SKShaukat Ali Khan
Shaukat Ali Khan
Concrete is used worldwide as a construction material in many projects. It exhibits a brittle nature, and fibers' addition to it improves its mechanical properties. Polypropylene (PP) fibers stand out as widely employed fibers in concrete. However, conventional micro-PP fibers pose challenges due to their smooth texture, affecting bonding within concrete and their propensity to clump during mixing due to their thin and soft nature. Addressing these concerns, a novel type of PP fiber is proposed by gluing thin fibers jointly and incorporating surface indentations to enhance mechanical anchorage. This study investigates the incorporation of macro-PP fibers into high-strength concrete, examining its fresh and mechanical properties. Three different concrete strengths 40 MPa, 45 MPa, and 50 MPa, were studied with fiber content of 0–1.5% v/f. ASTM specifications were utilized to test the fresh and mechanical properties, while the RILEM specifications were adopted to test the bond of bar reinforcements in concrete. Test results indicate a decrease in workability, increased air content, and no substantial shift in fresh concrete density. Hardened concrete tests, adding macro-PP fibers, show a significant increase in splitting tensile strength, bond strength, and flexural strength with a maximum increase of 34.5%, 35%, and 100%, respectively. Concrete exhibits strain-hardening behavior with 1% and 1.5% fiber content, and the flexural toughness increases remarkably from 2.2 to 47.1. Thus, macro PP fibers can effectively improve concrete's mechanical properties and resistance against crack initiation and spread.

19 June 2018 in Engineering, Technology & Applied Science Research
Verified
Journal Article
Open access
PDF file
Shahid IqbalShahid Iqbal
Shahid Iqbal
NUN. Ullah
N. Ullah
AAA. Ali
A. Ali
The bond between reinforcements and concrete is the only mechanism that transfers the tensile stresses from concrete to reinforcements. Several factors including chemical adhesion, roughness and reinforcement interface and bar bearing affect the bond strength of reinforcements with concrete. This work was carried out considering another varying factor which is maximum aggregate size. Four mixes of concrete with similar compressive strengths but different maximum aggregate sizes of 25.4mm, 19.05mm, 12.7mm and 9.53mm were used with the same bar size of 16mm. Compressive strength, splitting tensile strength and bond strength for each concrete mix were studied. Test results depict a slight increase in compressive and splitting tensile strength with decrease in maximum aggregate size. The bond strength remained at the same level with decrease in maximum aggregate size except at maximum aggregate size of 9.53mm when there was a drop in bond strength, despite better compressive and splitting tensile strengths. ACI-318 and FIB-2010 codes equation for bond strength calculation work well only when the maximum aggregate size is 12.7mm and above. Therefore, maximum aggregate size is critical for bond strength when smaller size aggregates are used.