We have fabricated and tested, to the best of our knowledge, the first microfluidic device monolithically integrated with planar chalcogenide glass waveguides on a silicon substrate. High-quality Ge23Sb7S70 glass films have been deposited onto oxide coated silicon wafers using thermal evaporation, and high-index-contrast channel waveguides have been defined using SF6 plasma etching. Microfluidic channel patterning in photocurable resin (SU8) and channel sealing by a polydimethylsiloxane (PDMS) cover completed the device fabrication. The chalcogenide waveguides yield a transmission loss of 2.3 dB/cm at 1550 nm. We show in this letter that using this device, N-methylaniline can be detected using its well-defined absorption fingerprint of the N-H bond near 1496 nm. Our measurements indicate linear response of the sensor to varying N-methylaniline concentrations. From our experiments, a sensitivity of this sensor down to a N-methylaniline concentration 0.7 vol. % is expected. Given the low-cost fabrication process used, and robust device configuration, our integration scheme provides a promising device platform for chemical sensing applications.
High-index-contrast compact microdisk resonators in thermally evaporated and chalcogenide glass films are designed and fabricated using standard UV lithography and characterized. Our pulley coupler configuration demonstrates coupling of the resonators to monolithically integrated photonic wire waveguides without resorting to demanding fine-line lithography. Microdisk resonators in support whispering-gallery-mode with cavity quality factors exceeding , the highest Q value reported in resonator structures in chalcogenide glasses to the best of our knowledge. We have successfully demonstrated a lab-on-a-chip prototype sensor device with the integration of our resonator with planar microfluidic systems. The sensor shows a refractive index sensitivity of (refractive index unit) and a wavelength resolution of through a resonant peak fit. This corresponds to a refractive index detection limit of RIU at in wavelength, which could be further improved by shifting the operating wavelength to a region where water absorption is reduced.
We demonstrate, for the first time to the best of our knowledge, low-loss, Si-CMOS-compatible fabrication of single-mode chalcogenide strip waveguides. As a novel route of chalcogenide glass film patterning, lift-off allows several benefits: leverage with Si-CMOS process compatibility; ability to fabricate single-mode waveguides with core sizes down to submicron range; and reduced sidewall roughness. High-index-contrast Ge23Sb7S70 strip waveguides have been fabricated using lift-off with excellent uniformity of loss propagation and the lowest loss figure of reported to date. We also show that small core Ge23Sb7S70 rib waveguides can be fabricated via lift-off as well, with loss figures lower than 0.5 dB/cm. Additionally, we find through waveguide modal analysis that although overall transmission loss is low, the predominant source of this loss comes from scattering at the sidewalls.
1 October 2009 in Journal of Solid State Chemistry