In this work, we have deposited the diamond-like carbon (DLC) coating on the tungsten carbide (WC) tool insert using the thermal chemical vapor deposition (CVD) method. For the growth of DLC coating, sugarcane bagasse was used as a carbon precursor. Raman spectroscopy, a field emission scanning electron microscope (FESEM), and X-ray diffraction (XRD) were used to confirm the presence of DLC coating on the tungsten carbide tool inserts. The hardness tests were also performed for inspecting the microhardness induced by the self-developed DLC coating on the tungsten carbide (WC) tool insert. To determine the optimum process parameters for the turning operation on an aluminum (6061) workpiece using a self-developed DLC-coated tungsten carbide (WC) tool insert, we have applied the technique for order preference by similarity to ideal solution (TOPSIS) methods. The process parameters considered for the optimization were feed rate, cutting speed, and depth of cut. Whereas chosen response variables were flank wear, temperature in the cutting zone, and surface roughness. TOPSIS is utilized to analyze the effects of selected input parameters on the selected output parameters. This study in this paper revealed that it was advantageous to develop the DLC coating on the tungsten carbide tool inserts for the machining applications. The results also revealed that a 0.635 mm depth of cut, feed rate of 0.2 mm/rev, and cutting speed of 480 m/min were the optimum combination of process parameters.
In this research work we have coated WC (tungsten carbide) tool inserts with diamond like carbon coatings. The deposition was done using the thermal Chemical Vapour Deposition (CVD) method. We have used bagasse of sugarcane which is an agriculture waste as a carbon precursor for developing the diamond like carbon coatings. Surface finish, cutting temperature and cutting forces of as-developed diamond like carbon coatings on the WC inserts were examined and analyzed in this research work. For confirming the presence of diamond like carbon coatings on the surface of coated tungsten carbide (WC) tool inserts substrate we have used Raman spectroscopy, X-ray diffraction (XRD) and Field Emission Scanning Electron Microscope (Fe-SEM). The increase in the hardness on the developed coated samples were inspected by performing the hardness test on the coated substrates. The average evaluated Vickers Hardness number were found to be 1455.24 HV and 950.65 HV for both coated as well as un-coated samples respectively. This shows 53% rise in the hardness of the un-coated WC inserts.