Field surveys and experiments in a tilting flume on hyperconcentrated sand‐water mixture (SWM) flows were conducted. At slopes slightly smaller than the equilibrium slope, a rapid development of sand bars propagating upstream was observed. These bars consist of an almost horizontal terrace with subcritical flow, a steep lee‐side slope with supercritical flow, and a hydraulic jump between subsequent bars. The erosion processes on the bar are limited by the high sand concentrations and flow velocities on the steep slopes. As a result, the erosion rate is more moderate than predicted by the pickup functions used in classical sediment‐transport theory. A simple one‐dimensional model is presented to study the behavior of triangular schematized bars. From an analysis of the equations it is concluded that an increase in erosion rate requires an increase in bed slope to maintain equilibrium flow conditions. Finally, simulations with the model are compared with observations in the field and in the tilting flume. T...
Field surveys and experiments in two tilting flumes on hyperconcentrated sand‐water‐mixture (swm) flows were conducted. This paper is limited to supercritical flows over a flat bed. It is shown that an equilibrium slope can be defined at which sedimentation and erosion are in balance. For laminar flow conditions this slope is only dependent on the average sand concentration, whereas for turbulent conditions the flow rate per unit width is the main parameter. The sand concentration near the bed measured about 35% by volume for most test conditions. The vertical gradient in sand concentration decreased with increasing mean sand concentration, indicating a decrease in the damping of turbulence. The velocity distribution behaved fairly logarithmically, showing a variation in slope with varying sand concentration. A minimum value of the effective von Kármán constant was found at concentrations of about 20%. Finally, it appears plausible that at high concentrations a considerable growth of the viscous sublayer ...
Retrogressive breach failures or coastal flow slides occur naturally in the shoreface in fine sands near dynamic tidal channels or rivers. They sometimes retrogress into beaches, shoal margins and riverbanks where they can threaten infrastructure and cause severe coastal erosion and flood risk. Ever since the first reports were published in the Netherlands over a century ago, attempts have been made to understand the geo-mechanical mechanism of flow slides. In this paper we have established that events, observed during the active phase, are characterized by a slow but steady retrogression into the shoreline, often continuing for many hours. This can be explained by the breaching mechanism, as will be clarified in this paper. Recently, further evidence has become available in the form of video footage of active events in Australia and elsewhere, often publicly posted on the internet. All these observations justify the new term ‘retrogressive breach failure’ (RBF event). The mechanism has been confirmed in flume tests and in a field experiment. With a better understanding of the geo-mechanical mechanism, current protection methods can be better understood, and new defense strategies can be envisaged. In writing this paper, we hope that the coastal science and engineering communities will better recognize and understand these intriguing natural events.
31 March 2018 in Earth Surface Processes and Landforms