The aim of the study was to develop an orthopedic implant coating in the form of vancomycin-loaded collagen/hydroxyapatite layers (COLHA+V) that combine the ability to prevent bone infection with the ability to promote enhanced osseointegration. The ability to prevent bone infection was investigated employing a rat model that simulated the clinically relevant implant-related introduction of bacterial contamination to the bone during a surgical procedure using a clinical isolate of Staphylococcus epidermidis. The ability to enhance osseointegration was investigated employing a model of a minipig with terminated growth. Six weeks following implantation, the infected rat femurs treated with the implants without vancomycin (COLHA+S. epidermidis) exhibited the obvious destruction of cortical bone as evinced via a cortical bone porosity of up to 20% greater than that of the infected rat femurs treated with the implants containing vancomycin (COLHA+V+S. epidermidis) (3%) and the non-infected rat femurs (COLHA+V) (2%). The alteration of the bone structure of the infected COLHA+S. epidermidis group was further demonstrated by a 3% decrease in the average Ca/P molar ratio of the bone mineral. Finally, the determination of the concentration of vancomycin released into the blood stream indicated a negligible systemic load. Six months following implantation in the pigs, the quantified ratio of new bone indicated an improvement in osseointegration, with a two-fold bone ingrowth on the COLHA (47%) and COLHA+V (52%) compared to the control implants without a COLHA layer (27%). Therefore, it can be concluded that COLHA+V layers are able to significantly prevent the destruction of bone structure related to bacterial infection with a minimal systemic load and, simultaneously, enhance the rate of osseointegration.

Conventional electrospinning produces randomly ordered nanofibers, however many potential applications require precisely defined morphology and anisotropic properties of nanofibrous materials. In this work, a collector consisting of two segments has been used to prepare uniaxially ordered nanofibers. Optimized collector design comes from both analytical calculations of electrostatic strength in the vicinity of the electrodes and from experimental verification by polyvinyl alcohol nanofibers fabrication. The transversal electric strength is a key factor in achieving very well aligned nanofibers. The results presented here help provide a better understanding of the electrically induced alignment mechanism.

The last decade has seen an extensive development of the field of nanomaterials which are currently being used in their first commercial applications. This rapid development is necessarily connected with certain technological demands. This paper describes a technology for the manufacture of nanomaterials from solutions by electrostatic spinning or spraying. Although this method has been well known since the last century, there are still only a few high-quality devices that can be used for the research of new nanomaterials. The main reason for this is that the process of nanomaterials manufacturing is influenced by numerous processing parameters which need to be properly regulated, and furthermore all device components must be resistant to interference from high voltage. The technological requirements are thus stringent. Moreover, such a device must be multifunctional, compact and affordable. This paper describes the technical aspects of a unique laboratory device, i.e., device modules and central control, measured processing parameters, and their effect on the produced materials. The developed laboratory device meets the most demanding criteria for a nanotechnological laboratory device and helps facilitate and speed up the research and development of new nanomaterials produced in high electrostatic field.