Iodine (I) and selenium (Se) are included in the group of beneficial elements. They both play important roles in humans and other animals, particularly in the regulation of thyroid functioning. A substantial percentage of people around the world suffer from health disorders related to the deficiency of these elements in the diet. Salicylic acid (SA) is a compound similar to phytohormones and is known to improve the efficiency of I biofortification of plants. The influence of SA on Se enrichment of plants has not, however, been recognised together with its effect on simultaneous application of I and Se to plants. Two-year studies (2014–2015) were conducted in a greenhouse with hydroponic cultivation of lettuce in an NFT (nutrient film technique) system. They included the application of I (as KIO3), Se (as Na2SeO3) and SA into the nutrient solution. KIO3 was used at a dose of 5 mg I•dm-3 (i.e., 39.4 µM I), while Na2SeO3 was 0.5 mg Se•dm-3 (i.e., 6.3 µM Se). SA was introduced at three doses: 0.1, 1.0 and 10.0 mg∙dm-3 nutrient solutions, equivalent to 0.724 µM, 7.24 µM and 72.4 µM SA, respectively. The tested combinations were as follows: 1.) control, 2.) I + Se, 3.) I + Se + 0.1 mg SA∙dm-3, 4.) I + Se + 1.0 mg SA∙dm-3 and 5.) I + Se + 10.0 mg SA∙dm-3. The applied treatments had no significant impact on lettuce biomass (leaves and roots). Depending on the dose, a diverse influence of SA was noted with respect to the efficiency of I and Se biofortification; chemical composition of leaves; and mineral nutrition of lettuce plants, including the content of macro- and microelements and selenocysteine methyltransferase (SMT) gene expression. SA application at all tested doses comparably increased the level of selenomethionine (SeMet) and decreased the content of SA in leaves.
The low content of iodine (I) and selenium (Se) forms available to plants in soil is one of the main causes of their insufficient transfer in the soil-plant-consumer system. Their deficiency occurs in food in the majority of human and farm animal populations around the world. Plant response to simultaneous fertilization with I and Se has not been investigated in depth. Neither I nor Se is essential for higher plants but can be considered as a beneficial element. The study (conducted in 2012–2014) included soil fertilization of carrot cv. “Kazan F1” in the following combinations: 1. Control; 2. KI; 3. KIO3; 4. Na2SeO4; 5. Na2SeO3; 6. KI+Na2SeO4; 7. KIO3+Na2SeO4; 8. KI+Na2SeO3; 9. KIO3+Na2SeO3. I and Se were applied twice: before sowing and as top-dressing in a total dose of 5 kg I•ha−1 and 1 kg Se•ha−1. No negative effects of I and Se fertilization were noted with respect to carrot yield. Higher accumulation and the uptake by leaves and storage roots of I and Se were obtained after the application of KI than KIO3, as well as of Na2SeO4 than Na2SeO3, respectively. Transfer factor values for leaves and roots were about a dozen times higher for Se than for I. Selenomethionine content in carrot was higher after fertilization with Na2SeO4 than with Na2SeO3. However, it was the application of Na2SeO3, KI+Na2SeO3 and KIO3+Na2SeO3 that resulted in greater evenness within the years and a higher share of Se from selenomethionine in total Se in carrot plants. Consumption of 100 g f.w. of carrots fertilized with KI+Na2SeO3 and KIO3+Na2SeO3 can supply approximately or slightly exceed 100% of the Recommended Daily Allowance for I and Se. Moreover, the molar ratio of I and Se content in carrot fertilized with KI+Na2SeO3 and KIO3+Na2SeO3 was the best among the research plots.
1 November 2019 in Plant Physiology and Biochemistry