Based on a porous carbon electrode, capacitive deionization (CDI) is a promising desalination technology in which ions are harvested and stored in an electrical double layer. However, the ion removal capacity of CDI systems is not sufficient for desalting high-concentration saline water. Here, we report a novel desalination technique referred to as “hybrid capacitive deionization (HCDI)”, which combines CDI with a battery system. HCDI consists of a sodium manganese oxide (Na4Mn9O18) electrode, an anion exchange membrane, and a porous carbon electrode. In this system, sodium ions are captured by the chemical reaction in the Na4Mn9O18 electrode, whereas chloride ions are adsorbed on the surface of the activated carbon electrode during the desalination process. HCDI exhibited more than double the ion removal sorption capacity (31.2 mg g−1) than a typical CDI system (13.5 mg g−1). Moreover, it was found that the system has a rapid ion removal rate and excellent stability in an aqueous sodium chloride solution. These results thus suggest that the HCDI system could be a feasible method for desalting a highly concentrated sodium chloride solution in capacitive techniques.
The demand for fresh water has been increasing, caused by the growing population and industrialization throughout the world. In this study, we report a capacitive-based desalination system using Prussian blue materials in a rocking chair desalination battery, which is composed of sodium nickel hexacyanoferrate (NaNiHCF) and sodium iron HCF (NaFeHCF) electrodes. In this system, ions are removed not only by charging steps but also by discharging steps, and it is possible to treat actual seawater with this system because the Prussian blue material has a high charge capacity with a reversible reaction of alkaline cations. Here, we demonstrate a rocking chair desalination battery to desalt seawater, and the results show that this system has a high desalination capacity (59.9 mg/g) with efficient energy consumption (0.34 Wh/L for 40% Na ion removal efficiency).
The demand for lithium has greatly increased with the rapid development of rechargeable batteries. Currently, the main lithium resource is brine lakes, but the conventional lithium recovery process is time consuming, inefficient, and environmentally harmful. Rechargeable batteries have been recently used for lithium recovery, and consist of lithium iron phosphate as a cathode. These batteries feature promising selectivity between lithium and sodium, but they suffer from severe interference from coexisting magnesium ions, an essential component of brine, which has prompted further study. This study reports on a highly selective and energy-efficient lithium recovery system using a rechargeable battery that consists of a λ-MnO2 positive electrode and a chloride-capturing negative electrode. This system can be used to recover lithium from brine even in the presence of magnesium ions as well as other dissolved cations. In addition, lithium recovery from simulated brine is successfully demonstrated, consuming 1.0 W h per 1 mole of lithium recovered, using water similar to that from the artificial brine, which contains various cations (mole ratio: Na/Li ≈ 15.7, K/Li ≈ 2.2, Mg/Li ≈ 1.9).