Angela Myrra Puspita Dewi

Mrs. Angela Myrra Puspita Dewi

State University of Papua, Manokwari, Papua Barat, Indonesia
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 March 2022 in Polymers
Verified
Journal Article
Open access
PDF file
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
USUmar Santoso
Umar Santoso
YPYudi Pranoto
Yudi Pranoto
DMDjagal Wiseso Marseno
Djagal Wiseso Marseno
To elucidate the pretreatment of a heat moisture treatment that could increase the DS and hydrophobicity of OSA starch, the effect of the moisture level of the HMT process on the physicochemical properties was investigated. The higher moisture content (MC) in the HMT process led to a decreasing degree of crystallinity and gelatinization enthalpy and also produced surface damage and cracking of the granules. HMT pretreatment with the right moisture content resulted in OSA starch with the maximum DS value and reaction efficiency. Pre-treatment HMT at 25% MC (HMT-25) followed by OSA esterification exhibited the highest DS value (0.0086) and reaction efficiency (35.86%). H25-OSA starch has been shown to have good water resistance (OAC 1.03%, WVP 4.92 × 10−5 g/s m Pa, water contact angle 88.43°), and conversely, has a high cold water solubility (8.44%). Based on FTIR, there were two new peaks at 1729 and 1568 cm−1 of the HMT-OSA starch, which proved that the hydroxyl group of the HMT starch molecule had been substituted with the carbonyl and carboxyl ester groups of OSA.

8 December 2020 in Biodiversitas Journal of Biological Diversity
Verified
Journal Article
Closed access
PDF file
BSBudi Santoso
Budi Santoso
ZSZita Letviany Sarungallo
Zita Letviany Sarungallo
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
Santoso B, Sarungallo ZL, Puspita AM. 2021. Physicochemical and functional properties of spineless, short-spines, and long-spines sago starch. Biodiversitas 22: 137-143. Starch application in the food and non-food industries is influenced by their properties. The aim of this research was to characterize the physicochemical and functional of spineless, short-spines, and long-spine sago starch. Starch morphology for all types had an oval shape with a smooth surface, which was proved by the X-ray diffraction analysis. The proximate composition did not differ for all types of sago, except the protein of spineless sago type was slightly higher but it did not affect the profile and gelatinization process. The amylose content of spineless, short spines and long spine of sago starch was 33.61 %db, 38.47 % db, and 37.59 % db, respectively; categorized as a high in amylose then tends to be stickyless. The value of peak viscosity and setback of spineless sago (7571.0 cP and 1495.0 cP) and long spines sago (7608.0 cP and 923.0 cP) were higher than the short spines sago starch (1271.0 cP and 538.0 cP). Therefore, the spineless and the long spines sago starch are suitable as thickener and fillers, while the short spines sago starch is suggested for cakes and bakery products because it will not harden when the product is cold.

18 July 2023 in Food Science and Technology
Verified
Journal Article
Open access
PDF file
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
USUmar Santoso
Umar Santoso
YPYudi Pranoto
Yudi Pranoto
DMDjagal Wiseso Marseno
Djagal Wiseso Marseno
This study presented the impact of pH and octenyl succinic anhydride (OSA) concentration on the esterification reaction of heat-moisture-treated sago starch (HMT-S) using response surface methodology to achieve optimum degree of substitution (DS), reaction efficiency (RE), and water contact angle (CA). The results showed that HMT-OSA sago starch (HMT-OS) starch exhibited an optimum pH of 7.26 and an OSA concentration of 4.53%. The DS value, RE, and water CA of optimized HMT-OS starch were 0.0121, 33.07%, and 90.11°, respectively. Furthermore, the optimized HMT-OS was used to evaluate the effect of starch modification on film characteristics. HMT-OS film has the best moisture-proof and mechanical properties compared to control (NS), HMT-S, and N-OS films, as indicated by lower water vapor permeability (28.69 g H2O.mm/s.m2.Pa × 10-11), water solubility (26.61%), higher CA (104.40°), elongation at break (85.63%), and transparency (3.25% mm-1). According to the scanning electron micrographic images, the absence of cracks or pores was attributed to the waterproof properties and flexibility of the film. Conversely, x-ray diffraction results showed that the crystallinity of HMT-OS film decreased to 36.05%.

11 June 2024 in Advance Sustainable Science Engineering and Technology
Verified
Journal Article
Open access
PDF file
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
USUmar Santoso
Umar Santoso
YPYudi Pranoto
Yudi Pranoto
DMDjagal Wiseso Marseno
Djagal Wiseso Marseno
The amount of solvent affects the effectiveness of the extraction, so the chemical components are extracted entirely from the plant. This study investigated the best ratio of Akway bark : solvent (ethanol) to produce Akway extract with the highest antioxidant activity. Extraction with the treatment of Akway skin: ethanol ratio of 1:2; 1:4; 1:6 (b/v) was carried out and then the results were tested for total phenolic and flavonoid content and antioxidant activity. The best Akway bark:ethanol ratio was obtained at 1:4 (b/v) ratio with 9.54% extract yield, 289.57 mg GAE/g total phenolic content, 185.47 mg eq quercetin/g total flavonoids. Akway bark extract has potential as a source of antioxidants as indicated by its high antioxidant activity with DPPH free radical scavenging and ferric reducing activity of 50% (IC50) at extract concentrations of 16.59 µg/mL extract and 60.93 µg/mL extract, and carotene bleaching inhibition activity of 85.76%. There are 4 types of phenolic compounds and 4 types of flavonoid compounds identified with the highest percentage of components, namely Pereniporin B (57%).

23 July 2024 in PengabdianMu: Jurnal Ilmiah Pengabdian kepada Masyarakat
Verified
Journal Article
Open access
PDF file
ETEduard Fransisco Tethool
Eduard Fransisco Tethool
AJAbadi Jading
Abadi Jading
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
Sago utilization in Papua has not been maximized due to the limited knowledge and abilities of local communities. This technology dissemination activity aims to increase the utilization of local Papuan resources as a substitute for wheat, by applying the equipment and processing methods that have been developed. The method used is tool dissemination and training on sago starch modification and the manufacture of various processed products in the development of business units. Prototype technology disseminated in the form of starch acidification equipment and drying equipment with UV irradiation. The trial results showed that the capacity of the acidification tool produced was 50 kg of wet sago starch (50% moisture content) with an acidification process duration of 3 days. Meanwhile, the capacity of the dryer is 25 kg of wet sago starch (50% moisture content) with a drying time of ± 20 hours. The use of disseminated tools can reduce material contact with contaminant sources resulting in better product quality.

16 March 2025 in Journal of Food and Agricultural Product
Verified
Journal Article
Open access
PDF file
JEJohn Dewan Emanratu
John Dewan Emanratu
BSBudi Santoso
Budi Santoso
Angela Myrra Puspita DewiAngela Myrra Puspita Dewi
Angela Myrra Puspita Dewi
The physical, mechanical and degradability properties of bioplastics made from natural and Heat Moisture Treatment (HMT) modified sago starch and their application as packaging for ground coffee were studied. HMT modification increased the amylose content by 4% and decreased the expandability by 7.16%. HMT-modified starch can also reduce the hydrophilicity of bioplastics as indicated by a decrease in WVTR value by 10% and solubility by 59%. The results also showed that bioplastic from natural and HMT-modified sago starch can be degraded on day 9 by 16% and 34%, respectively. Bioplastic from HMT-modified sago starch can be applied as a packaging for ground coffee with the speed of dissolving in hot water for 116 seconds. Keywords: sago starch, Heat Moisture Treatment, ground coffee