James Kofi Arthur

Dr. James Kofi Arthur

Bucknell University, Lewisburg, Pennsylvania, USA

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2009 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
James Kofi ArthurJames Kofi Arthur
James Kofi Arthur
DRDouglas W. Ruth
Douglas W. Ruth
MTMark F. Tachie
Mark F. Tachie
This paper reports an experimental investigation of pressure-driven flow through models of porous media. Each model porous medium is a square array of circular acrylic rods oriented across the flow in a rectangular channel. The solid volume fraction φ of the arrays ranged from 0.01 to 0.49. Three boundary conditions were studied. In the first boundary condition, the model porous medium was installed on the lower wall of the channel only and was bounded by a free zone. In the second and third boundary conditions, porous media of equal and unequal φ were arranged on the lower and upper channel walls so that the two media touched (second boundary condition), and did not touch (third boundary condition). Using water as the working fluid, the Reynolds number was kept low so that inertia was not a factor. Particle image velocimetry was used to obtain detailed velocity measurements in the streamwise-transverse plane of the test section. The velocity data were used to study the effects of φ and the different boundary conditions on the flow through and over the porous medium, and at the interface. For the first boundary condition, it was observed that at φ = 0.22, flow inside the porous medium was essentially zero, and the slip velocity at the porous medium and free zone interface decayed with permeability. In the second and third boundary conditions, flow communication between the porous media was observed to be dependent on the combinations of φ used, and the trends of the slip velocities at the interface between the two porous media obtained for that boundary condition were indicative of complicated interfacial flow.

1 December 2020 in Advances in Water Resources
Verified
Journal Article
Closed access
James Kofi ArthurJames Kofi Arthur
James Kofi Arthur


6 October 2022 in Experimental Thermal and Fluid Science
Verified
Journal Article
Closed access
James Kofi ArthurJames Kofi Arthur
James Kofi Arthur

25 September 2010 in Transport in Porous Media
Verified
Journal Article
Closed access
PDF file
DRD. W. Ruth
D. W. Ruth
James Kofi ArthurJames Kofi Arthur
James Kofi Arthur

23 September 2021 in Fluids
Verified
Journal Article
Open access
PDF file
James Kofi ArthurJames Kofi Arthur
James Kofi Arthur
There are several natural and industrial applications where turbulent flows over compact porous media are relevant. However, the study of such flows is rare. In this paper, an experimental investigation of turbulent flow through and over a compact model porous medium is presented to fill this gap in the literature. The objectives of this work were to measure the development of the flow over the porous boundary, the penetration of the turbulent flow into the porous domain, the attendant three-dimensional effects, and Reynolds number effects. These objectives were achieved by conducting particle image velocimetry measurements in a test section with turbulent flow through and over a compact model porous medium of porosity 85%, and filling fraction 21%. The bulk Reynolds numbers were 14,338 and 24,510. The results showed a large-scale anisotropic turbulent flow region over and within the porous medium. The overlying turbulent flow had a boundary layer that thickened along the stream by about 90% and infiltrated into the porous medium to a depth of about 7% of the porous medium rod diameter. The results presented here provide useful physical insight suited for the design and analyses of turbulent flows over compact porous media arrangements.