Sanjay Mittal

Sanjay Mittal

Auto-generated profile, based on publicly available information

Sanjay Mittal

Indian Institute of Technology Kanpur

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 February 2003 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
SMSanjay Mittal
Sanjay Mittal
BKBhaskar Kumar
Bhaskar Kumar
Flow past a spinning circular cylinder placed in a uniform stream is investigated via two-dimensional computations. A stabilized finite element method is utilized to solve the incompressible Navier–Stokes equations in the primitive variables formulation. The Reynolds number based on the cylinder diameter and free-stream speed of the flow is 200. The non-dimensional rotation rate, α (ratio of the surface speed and freestream speed), is varied between 0 and 5. The time integration of the flow equations is carried out for very large dimensionless time. Vortex shedding is observed for α < 1.91. For higher rotation rates the flow achieves a steady state except for 4.34 < α < 4:70 where the flow is unstable again. In the second region of instability, only one-sided vortex shedding takes place. To ascertain the instability of flow as a function of α a stabilized finite element formulation is proposed to carry out a global, non-parallel stability analysis of the two-dimensional steady-state flow for small disturbances. The formulation and its implementation are validated by predicting the Hopf bifurcation for flow past a non-rotating cylinder. The results from the stability analysis for the rotating cylinder are in very good agreement with those from direct numerical simulations. For large rotation rates, very large lift coefficients can be obtained via the Magnus effect. However, the power requirement for rotating the cylinder increases rapidly with rotation rate.

14 December 2007 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
TPT. K. Prasanth
T. K. Prasanth
SMS. Mittal
S. Mittal
Results are presented for a numerical simulation of vortex-induced vibrations of a circular cylinder of low non-dimensional mass (m* = 10) in the laminar flow regime (60 < Re < 200). The natural structural frequency of the oscillator, fN, matches the vortex shedding frequency for a stationary cylinder at Re = 100. This corresponds to fND2/ν = 16.6, where D is the diameter of the cylinder and ν the coefficient of viscosity of the fluid. A stabilized space–time finite element formulation is utilized to solve the incompressible flow equations in primitive variables form in two dimensions. Unlike at high Re, where the cylinder response is known to be associated with three branches, at low Re only two branches are identified: ‘initial’ and ‘lower’. For a blockage of 2.5% and less the onset of synchronization, in the lower Re range, is accompanied by an intermittent switching between two modes with vortex shedding occurring at different frequencies. With higher blockage the jump from the initial to lower branch is hysteretic. Results from free vibrations are compared to the data from experiments for forced vibrations reported earlier. Excellent agreement is observed for the critical amplitude required for the onset of synchronization. The comparison brings out the possibility of hysteresis in forced vibrations. The phase difference between the lift force and transverse displacement shows a jump of almost 180° at, approximately, the middle of the synchronization region. This jump is not hysteretic and it is not associated with any radical change in the vortex shedding pattern. Instead, it is caused by changes in the location and value of the maximum suction on the lower and upper surface of the cylinder. This is observed clearly by comparing the time-averaged flow for a vibrating cylinder for different Re. While the mean flow for Re beyond the phase jump is similar to that for a stationary cylinder, it is associated with a pair of counter-rotating vortices in the near wake for Re prior to the phase jump. The phase jump appears to be one of the mechanisms of the oscillator to self-limit its vibration amplitude.

6 October 2010 in International Journal for Numerical Methods in Fluids
Verified
Journal Article
Closed access
PDF file
SSSubhankar Sen
Subhankar Sen
SMSanjay Mittal
Sanjay Mittal
GBGautam Biswas
Gautam Biswas

10 February 2009 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
SSSubhankar Sen
Subhankar Sen
SMSanjay Mittal
Sanjay Mittal
GBGautam Biswas
Gautam Biswas
The steady two-dimensional laminar flow around a stationary circular cylinder has been investigated via a stabilized finite-element method. The Reynolds numberReis based on the cylinder diameter and free-stream speed. The results have been presented for 6 ≤Re≤ 40 and the blockages between 0.000125 and 0.80. The blockageBis the ratio of the cylinder diameter to the domain width. There is large scatter in the value ofRes, reported in the literature, marking the onset of the flow separation. From the present study theResis found to be 6.29, approximately forB= 0.005. The effect of the blockage on the characteristic flow parameters is found to be insignificant forB≤ 0.01. The bubble length, separation angle andResexhibit non-monotonic variation with the blockage. It is for the first time that such a behaviour for the separation angle andResis being reported. Two types of boundary conditions at the lateral walls have been studied: the slip wall and towing tank. In general for high blockage, the results from the slip boundary condition are closer to the ones for the unbounded flow. In that sense, the use of the slip boundary condition as opposed to the towing tank boundary condition on the lateral walls is advocated. The bubble length, separation angle, base suction, total drag, pressure drag, viscous drag and maximum vorticity on the cylinder surface for the steady flow are found to vary asRe,Re−0.5,Re−1,Re−0.5,Re−0.64,Re−0.60andRe0.5, respectively. The extrapolated results for the steady flow, for higherRe, are found to match quite well with the other results from the literature.

11 November 2004 in International Journal for Numerical Methods in Fluids
Verified
Journal Article
Closed access
PDF file
SSS. P. Singh
S. P. Singh
SMS. Mittal
S. Mittal

28 February 2001 in International Journal for Numerical Methods in Fluids
Verified
Journal Article
Closed access
PDF file
SMS. Mittal
S. Mittal
ARA. Raghuvanshi
A. Raghuvanshi