30 January 2012 in Optics Express
Planar-lightwave-circuit (PLC)-type graphene polarizers are fabricated by using a low loss optical polymer waveguide. The optical characteristics are investigated at a wavelength of 1.31 µm. By interface engineering with a UV-curable perfluorinated acrylate polymer resin, the graphene’s electrical properties are tuned to support a transverse-magnetic (TM) or transverse-electric (TE) surface wave. Thus, the fabricated PLC-type graphene polarizer serves alternatively as a TM-pass or TE-pass polarizer depending on the absence or presence of the upper-cladding layer. The proposed planar-type graphene polarizer can be exploited further for on-chip photonic integrated circuit and devices.
30 July 2014 in ACS Applied Materials & Interfaces
15 November 2011 in Optics Express
We perform experimental investigations on the characteristics of graphene-based plasmonic waveguides for development of photonic integrated circuits. By embedding chemical vapor deposited graphene strip in a photoactive UV curable perfluorinated acrylate polymer with a low refractive index and material loss, the two-dimensional metal-like plasmonic waveguide demonstrated as a light signal guiding medium for high-speed optical data transmission. The fabricated graphene-based plasmonic waveguide supports the transverse-magnetic (TM) polarization modes with the averaged extinction ratio of 19 dB at a wavelength of 1.31 µm. The 2.5 Gbps optical signals were successfully transmitted via 6 mm-long graphene plasmonic waveguides. The proposed graphene-based plasmonic waveguides can be exploited further for development of next-generation photonic integrated circuit and devices.
12 August 2008 in Optics Express
We demonstrate a novel on-board chip-to-chip optical interconnect using long-range surface plasmon polariton (LR-SPP) waveguides that feature 2.5-cm-long gold strips embedded in a low loss polymer cladding. A TM-mode vertical-cavity surface-emitting laser (VCSEL) operating at a wavelength of 1.3 µm was butt-coupled into the waveguides in order to excite a fundamental LR-SPP mode and then the transmitted light was received with a photo-diode (PD). The waveguide width is varied in the range of 1.5–5.0 µm in order to optimize the insertion loss where the 3-µm-wide waveguide provides a minimum insertion loss of -17 dB, consisting of 6 dB/cm propagation loss and 2 dB coupling loss. An interconnect system based on the optimized waveguide with a 4-channel array is assembled with the arrayed optoelectronic chips. It shows the feasibility of 10 Gbps (2.5 Gbps×4 channels) signal transmission indicating that the LR-SPP waveguide is a potential transmission line for optical interconnection.
30 June 2014 in Optics Letters
To extend the application of an emerging plasmonic material, vanadium dioxide (), in silicon photonics technology, we propose a complementary metal-oxide-semiconductor (CMOS)-compatible hybrid plasmonic modulator using an insulator-metal phase transition. The optical device is based on a directional coupler that consists of a Si waveguide and a hybrid plasmonic waveguide. By electrically triggering the phase of with a driving voltage of 2 V, the propagation loss of the hybrid plasmonic waveguide is switched, and hence the output optical power is modulated. The on/off extinction ratio is larger than 3.0 dB on the entire C-band.
26 January 2010 in Optics Express
A hybrid plasmonic waveguide structure is proposed and fabricated for low-loss lightwave guiding along a metal stripe core. By embedding Au stripe in dual slab waveguides with high refractive-index contrast, the field of the guided mode is confined more in the two dielectric core layers. Thus, the propagation loss is significantly reduced. The guided mode is like a combination of a fundamental long-range surface plasmon polariton strip mode and a dual symmetric dielectric slab mode. We fabricate 5 nm-thick Au stripe optical waveguides and measure the optical properties at a wavelength of 1.31 µm. The propagation loss is less than 1.0 dB/cm with the metal stripe width of 1–5 μm.