6 August 2022 in Environmental Monitoring and Assessment
KAKarina Siqueira Azevedo
MMMaria Gabriela Batista Melo
Maria Gabriela Batista Melo
MOMaria Caroline Oliveira
+3
1 July 2016 in Desalination and Water Treatment
Recently, researchers working with aerated bioreactors identified a different microbial organization in the form of aerobic granules. In this configuration, bacteria clump together more tightly than conventional floc, which reduces biofilm formation on the membrane surface of membrane bioreactors and allows higher flux for longer time periods during filtration. This study examined the possible formation of aerobic granules treating paper mill effluent and compared the removal efficiency of organic matter from granular with the conventional flocculent sludge. The filterability of both types of sludge was also compared. Two reactors were operated in parallel with aerobic granular and flocculent sludge. Both systems achieved very high Biochemical oxygen demand (BOD5) and chemical oxygen demand (COD)-removal efficiencies. Sludge filtration tests showed a higher critical flux for granular sludge with total suspended solids (TSS) equal to 2,700 mg L−1. However, the opposite behavior was observed when the reactors were operated with a TSS value of 4,400 mg L−1.
3 January 2018 in PLOS ONE
ALAlice Do Carmo Precci Lopes
Alice Do Carmo Precci Lopes
FRFábio De Ávila Rodrigues
The Multi-Criteria Decision Analysis (MCDA) procedure was used to compare waste management options for kraft pulp mill sludge following its anaerobic digestion. Anaerobic digestion of sludge is advantageous because it produces biogas that may be used to generate electricity, heat and biofuels. However, adequate management of the digested sludge is essential. Landfill disposal is a non-sustainable waste management alternative. Kraft pulp mill digested sludge applied to land may pose risks to the environment and public health if the sludge has not been properly treated. This study is aimed to compare several recycling alternatives for anaerobically digested sludge from kraft pulp mills: land application, landfill disposal, composting, incineration, pyrolysis/gasification, and biofuel production by algae. The MCDA procedure considered nine criteria into three domains to compare digested sludge recycling alternatives in a kraft pulp mill: environmental (CO2 emission, exposure to pathogens, risk of pollution, material and energy recovery), economic (overall costs, value of products) and technical (maintenance and operation, feasibility of implementation). The most suitable management options for digested sludge from kraft pulp mills were found to be composting and incineration (when the latter was coupled with recycling ash to the cement industry). Landfill disposal was the worst option, presenting low performance in feasibility of implementation, risk of pollution, material and energy recovery.
1 March 2007 in Water Science & Technology
In the pulp and paper industry, the water use minimization is a constant target. One way to reduce water use is to recycle the effluent in a closed-cycle concept. In paper mills, the main source of liquid effluent is the so-called whitewater, which is the excess water, originated from pulp stock dewatering and other fibre contaminated water. This research studied the reuse of paper mill whitewater after membrane ultrafiltration (UF) in the paper machine and in the pulp bleach plant of an integrated mill. Contaminant removal and flux behaviour of the UF system were evaluated. The treatment by ultrafiltration was technically feasible and the treated whitewater had good potential to be reused in some processes in the paper machine. The reuse of ultrafiltered whitewater in the bleaching plant was not recommended because of the high level of soluble calcium present in this stream. Therefore, a combined treatment of the whitewater using the principle of precipitation and ultrafiltration was proposed showing good results and enabling the use of the treated whitewater in the bleach plant.
2 November 2017 in BioResources
Granulation is a gradual process that makes flocculent sludge granular through the simultaneous densification and selection of aggregates via sedimentation. The damage to the granule structure over time in a bioreactor operation is one of the most severe barriers to the practical application of the process. The addition of metal ions may increase aggregation rates and granular structure stability. Four sequential batch reactors fed with pulp mill effluent were operated and monitored. Three reactors contained aerobic granular sludge and one contained flocculent sludge. One granular sludge SBR received the addition of 100 mg∙L-1 of Ca2+, the second 200 mg∙L-1 of Ca2+, and the third received no intentional addition of calcium. The fourth SBR was operated with conventional flocculent sludge. The efficiency of the organic matter removal and the effect of calcium on the morphological characteristics of the granules formed were evaluated. The removal efficiency of the COD and the BOD was similar among all SBR, i.e., 60% and 90%, respectively. The addition of calcium did not interfere with granule size. The addition of 100 mg∙L-1 of Ca2+ increased the uniformity and the mechanical strength of the granules. It also increased approximately 36% of the settling velocity of the granules.
1 November 2010 in Water Science & Technology
The use of treated pulp mill effluent on eucalyptus plantation appears to be an attractive option for plant nutrition and water supply. It also constitutes a supplementary treatment process and a final disposal option for the mill effluent. This study aimed at the investigation and evaluation of the effects of bleached kraft pulp mill treated effluent on three typical Brazilian soils used for eucalyptus plantation. The effluent was characterized and five different application rates, defined according to the load of sodium, were tested in controlled environment experiments (greenhouse). After effluent application over a six month period an increase in the salinity of the studied soils was observed, although no soil dispersion was detected. The low content of some nutrients in the treated effluent indicated the need for fertilizer complementation. In general, the best biomass productivity and plant growth results were obtained in fine textured soil at a loading rate of 6.49 t Na ha−1. The good response of the soil-plant system under different effluent application rates showed the feasibility for the eucalyptus irrigation if adequate management practices and monitoring are carried out.