David S. Ginger

David S. Ginger

Auto-generated profile, based on publicly available information

David S. Ginger

University of Washington

Research Focus & Metrics

Academic Career Length

30Years (1997-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 May 2015 in Science
Verified
Journal Article
Closed access
PDF file
DQDane W. de Quilettes
Dane W. de Quilettes
SVSarah M. Vorpahl
Sarah M. Vorpahl
SSSamuel D. Stranks
Samuel D. Stranks
HNHirokazu Nagaoka
Hirokazu Nagaoka
GEGiles E. Eperon
Giles E. Eperon
DGDavid S. Ginger
David S. Ginger
Going toward the grains: Great strides have been made in improving the efficiency of organic-inorganic perovskite solar cells. Further improvements are likely to depend on understanding the role of film morphology on charge-carrier dynamics. de Quilettes et al. correlated confocal fluorescence microscopy images with those from scanning electron microscopy to spatially resolve the photoluminescence and carrier decay dynamics from films of organic-inorganic perovskites. Carrier lifetimes varied widely even between grains, and chemical treatments could improve lifetimes Science , this issue p. 683

4 August 2017 in Science Advances
Verified
Journal Article
Open access
PDF file
LZLijian Zuo
Lijian Zuo
HGHexia Guo
Hexia Guo
DDDane W. Dequilettes
Dane W. Dequilettes
SJSarthak Jariwala
Sarthak Jariwala
NMNicholas De Marco
Nicholas De Marco
YYYang Yang
Yang Yang
The solution processing of polycrystalline perovskite films introduces trap states that can adversely affect their optoelectronic properties. Motivated by the use of small-molecule surfactants to improve the optoelectronic performance of perovskites, we demonstrate the use of polymers with coordinating groups to improve the performance of solution-processed semiconductor films. The use of these polymer modifiers results in a marked change in the electronic properties of the films, as measured by both carrier dynamics and overall device performance. The devices grown with the polymer poly(4-vinylpyridine) (PVP) show significantly enhanced power conversion efficiency from 16.9 ± 0.7% to 18.8 ± 0.8% (champion efficiency, 20.2%) from a reverse scan and stabilized champion efficiency from 17.5 to 19.1% [under a bias of 0.94 V and AM (air mass) 1.5-G, 1-sun illumination over 30 min] compared to controls without any passivation. Treating the perovskite film with PVP enables a VOC of up to 1.16 V, which is among the best reported for a CH3NH3PbI3 perovskite solar cell and one of the lowest voltage deficits reported for any perovskite to date. In addition, perovskite solar cells treated with PVP show a long shelf lifetime of up to 90 days (retaining 85% of the initial efficiency) and increased by a factor of more than 20 compared to those without any polymer (degrading to 85% after ~4 days). Our work opens up a new class of chemical additives for improving perovskite performance and should pave the way toward improving perovskite solar cells for high efficiency and stability.

17 February 2023 in Science
Verified
Journal Article
Closed access
CLChongwen Li
Chongwen Li
XWXiaoming Wang
Xiaoming Wang
EBEnbing Bi
Enbing Bi
FJFangyuan Jiang
Fangyuan Jiang
SPSo Min Park
So Min Park
YYYanfa Yan
Yanfa Yan
Lewis base molecules that bind undercoordinated lead atoms at interfaces and grain boundaries (GBs) are known to enhance the durability of metal halide perovskite solar cells (PSCs). Using density functional theory calculations, we found that phosphine-containing molecules have the strongest binding energy among members of a library of Lewis base molecules studied herein. Experimentally, we found that the best inverted PSC treated with 1,3-bis(diphenylphosphino)propane (DPPP), a diphosphine Lewis base that passivates, binds, and bridges interfaces and GBs, retained a power conversion efficiency (PCE) slightly higher than its initial PCE of ~23% after continuous operation under simulated AM1.5 illumination at the maximum power point and at ~40°C for >3500 hours. DPPP-treated devices showed a similar increase in PCE after being kept under open-circuit conditions at 85°C for >1500 hours.

23 September 2022 in Science
Verified
Journal Article
Closed access
SSSiraj Sidhik
Siraj Sidhik
YWYafei Wang
Yafei Wang
MSMichael De Siena
Michael De Siena
RAReza Asadpour
Reza Asadpour
ATAndrew J. Torma
Andrew J. Torma
AMAditya D. Mohite
Aditya D. Mohite
Realizing solution-processed heterostructures is a long-enduring challenge in halide perovskites because of solvent incompatibilities that disrupt the underlying layer. By leveraging the solvent dielectric constant and Gutmann donor number, we could grow phase-pure two-dimensional (2D) halide perovskite stacks of the desired composition, thickness, and bandgap onto 3D perovskites without dissolving the underlying substrate. Characterization reveals a 3D–2D transition region of 20 nanometers mainly determined by the roughness of the bottom 3D layer. Thickness dependence of the 2D perovskite layer reveals the anticipated trends for n-i-p and p-i-n architectures, which is consistent with band alignment and carrier transport limits for 2D perovskites. We measured a photovoltaic efficiency of 24.5%, with exceptional stability ofT99(time required to preserve 99% of initial photovoltaic efficiency) of >2000 hours, implying that the 3D/2D bilayer inherits the intrinsic durability of 2D perovskite without compromising efficiency.

29 July 2016 in ACS Energy Letters
Verified
Journal Article
Open access
DDDane W. Dequilettes
Dane W. Dequilettes
SKSusanne Koch
Susanne Koch
SBSven Burke
Sven Burke
RPRajan K. Paranji
Rajan K. Paranji
ASAlfred J. Shropshire
Alfred J. Shropshire
DGDavid S. Ginger
David S. Ginger
We study the effects of a series of post-deposition ligand treatments on the photoluminescence (PL) of polycrystalline methylammonium lead triiodide perovskite thin films. We show that a variety of Lewis bases can improve the bulk PL quantum efficiency (PLQE) and extend the average PL lifetime, ⟨τ⟩, with large enhancements concentrated at grain boundaries. Notably, we demonstrate thin-film PLQE as high as 35 ± 1% and ⟨τ⟩ as long as 8.82 ± 0.03 μs at solar equivalent carrier densities using tri-n-octylphosphine oxide-treated films. Using glow discharge optical emission spectroscopy and nuclear magnetic resonance spectroscopy, we show that the ligands are incorporated primarily at the film surface and are acting as electron donors. These results indicate it is possible to obtain thin-film PL lifetime and PLQE values that are comparable to those from single crystals by control over surface chemistry.

30 April 2018 in Nature Photonics
Verified
Journal Article
Closed access
PDF file
IBIan L. Braly
Ian L. Braly
DDDane W. Dequilettes
Dane W. Dequilettes
LPLuis M. Pazos-Outón
Luis M. Pazos-Outón
SBSven Burke
Sven Burke
MZMark E. Ziffer
Mark E. Ziffer
HHHugh W. Hillhouse
Hugh W. Hillhouse