Oleg A. Lukanin

Oleg A. Lukanin

Auto-generated profile, based on publicly available information

Oleg A. Lukanin

Russian Academy of Sciences

Research Focus & Metrics

Academic Career Length

42Years (1985-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2007 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
OLO. A. Lukanin
O. A. Lukanin
AKA. A. Kadik
A. A. Kadik
The analysis of available data on the Fe3+/Fe2+ ratio of impact-produced glasses showed that tektites and some other types of impact glasses are reduced compared with the precursor target material. Possible reasons for the change in the degree of iron oxidation in the impact process are still debatable. Based on the analysis of redox reactions in relatively simple systems with iron in different oxidation states (Fe-O and SiO2-FeO-Fe2O3) and the available data on the influence of temperature, oxygen partial pressure (pO2), and total pressure (P tot) on the Fe3+/Fe2+ ratio of silicate melts, a model was proposed suggesting that the lower Fe3+/Fe2+ values of tektites formed in the impact process compared with the initial target material could be related to the characteristics of oxygen regime during the decompression stage following shock compression. One of the main prerequisites for the occurrence of reduction reactions involving iron and other elements is the attainment of high temperatures (>1800–2000°C) at a certain stage of decompression, providing the complete melting and partial evaporation of the material. When the vapor pressure in the system becomes equal to the total pressure during adiabatic decompression, a further decrease in P tot will be inevitably accompanied by a decrease in pO2 and, correspondingly, partial reduction of Fe3+ to Fe2+ in the melt. The reactions of decompression reduction occur under closed-system conditions and do not require oxygen removal from the system. The higher the temperature and Fe3+/Fe2+ ratio of the melt, the more extensive iron reduction can be observed during the final stages of decompression. If the temperatures attained during decompression after an impact event are sufficient (>2500–3000°C) for the complete evaporation of the material, the melt produced during subsequent condensation must be significantly more reduced than the initial material. The final stage of the impact process is characterized by a catastrophic expansion of the explosion cloud, condensation, and rapid cooling. During this stage, the system is already not closed. The quenched glasses of this stage record the redox state of earlier melts. In addition, they can contain microinclusions of the products of nonequilibrium vapor condensation with iron compounds of different oxidation states, including metallic iron and iron oxides (wüstite, magnetite, and hematite).

26 September 2013 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
OLO. A. Lukanin
O. A. Lukanin
BRB. N. Ryzhenko
B. N. Ryzhenko
NKN. A. Kurovskaya
N. A. Kurovskaya
The solubility of all possible Zn and Pb species in aqueous chloride fluids was evaluated by means of thermodynamic simulations in systems ZnO(PbO)-aqueous solution of NaCl (KCl, NaCl + HCl) within broad ranges of temperature (600–900°C), pressure (0.7–5 kbar), and chloride concentrations, under parameters corresponding to the crystallization and degassing of granitoid magmas in the Earth’s crust. Our simulation results demonstrate that the addition of Cl to the fluid phase in the form of Na(K)Cl and HCl significantly increases the concentrations of Cl-bearing Zn and Pb complexes and the total concentration of the metals in the solutions in equilibrium with the solid oxides. In Zn-bearing fluids, the Zn(OH) 2 0 , ZnOH+, and Zn(OH) 3 − —hydroxyl complexes and the ZnCl 2 0 , and ZnCl+ chlorocomplexes, which are predominant at low Cl concentrations (CCl < 0.05–0.1 m) give way to ZnCl 4 2− with increasing CCl, which becomes the predominant Zn species of the fluid at CCl > 0.1–0.5 m throughout the whole temperature range in question and pressures higher than 1 kbar. For Pb-bearing fluids, the T-P-X region dominated by the Pb(OH) 2 0 , and Pb(OH) 3 − hydroxyl complexes is remarkably wider than the analogous region for Zn, particularly at elevated temperatures (≥700°C) in alkaline solutions. An increase in CCl is associated with an increase in the concentration and changes in the speciation of Pb chlorocomplexes: PbCl 2 0 → PbCl 3 − → PbCl 4 2− . The concentrations of Zn and Pb chlorocomplexes increase with increasing pressure, decreasing temperature, and decrease pH with the addition of HCl to the system. It is demonstrated that the solubility of ZnO at any given T-P-X in alkaline solutions with low chloride concentrations are lower than the solubility of PbO. The Zn concentration increases more significantly than with the Pb concentration with increasing CCl and decreasing pH, so that the Zn concentration in acidic solutions is higher than the Pb concentration over broad ranges of temperature, pressure, and Cl concentration. Chloride complexes of Zn (ZnCl 2 0 , and ZnCl 4 2− ) and Pb (PbCl 2 0 , and PbCl 3 − are proved to be predominant within broad T-P-X-pH ranges corresponding to the parameters under which magmatic fluid are generated. Our simulation results confirm the hypothesis that chlorocomplexes play a leading role in Zn and Pb distribution between aqueous chloride fluids and granitic melts. These simulation results are consistent with experimental data on the Zn and Pb distribution coefficients (D(Zn)f/m and D(Pb)f/m, respectively) between aqueous chloride fluids and granitic melts that demonstrated that (1) D(Zn)f/m and D(Pb)f/m increase with increasing Na and K chloride concentrations in the aqueous fluid, (2) both D(Zn)f/m and D(Pb)f/m drastically increase when HCl is added to the fluid, and (3) (D(Zn)f/m is higher than D(Pb)f/m at any given T-P-X parameters. The experimentally established decrease in D(Zn)f/m and D(Pb)f/m with increasing pressure (at unchanging temperature and Cl concentration) is likely explained by an increase in the alkalinity of the aqueous chloride fluid in equilibrium with granite melt and, correspondingly, a decrease in the Zn and Pb solubility in this fluid.

20 October 2010 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
OLO. A. Lukanin
O. A. Lukanin
VDV. F. Dernov-Pegarev
V. F. Dernov-Pegarev
This paper reports the results of numerical simulation for the behavior of rare earth elements (REE) during decompression degassing of H2O- and Cl-bearing granite melts at pressures decreasing from 3 to 0.5–0.3 kbar under near isothermal conditions (800 ± 25°C). Fluid phase in equilibrium with the melt contains mainly chloride REE complexes, and their behavior during magma degassing is, therefore, intimately related to the behavior of chlorine. It was shown that the contents and distribution patterns of REE in the aqueous chloride fluid phase formed during decompression vary considerably depending on (1) the contents of volatiles (Cl and H2O) in the initial melt, (2) the redox state of the magma, and (3) the dynamics of fluid phase separation from magmas during their ascent toward the Earth’s surface. During decompressiondriven degassing, the contents of both Cl and REE in the fluid decrease, especially dramatically under opensystem conditions. The REE patterns of the fluid phase compared with those of the melt are characterized by a higher degree of light to heavy REE fractionation. A weak negative Eu anomaly may be present in the REE patterns of Cl-rich fluids formed during the early stages of degassing at relatively high pressures. At a further decrease in pressure and Cl content in the fluid, it is transformed into a positive Eu anomaly increasing during decompression degassing. Such an anomalous behavior of Eu during degassing is related to its occurrence in magmatic melts in two valence states, Eu3+ and Eu2+, whereas the other REE occur in melts mainly as (REE)3+. The Eu3+/Eu2+ ratio of melt is controlled by the redox state of the magmatic system. The higher the degree of melt reduction, the more pronounced the anomalous behavior of Eu during decompression degassing. The amount of REE extracted by fluid from melt during various stages of degassing does not significantly influence the content and distribution patterns of REE in the melt.

21 August 2015 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
OLO. A. Lukanin
O. A. Lukanin
Based on available experimental data, a computer model was developed for the description of chlorine distribution between a magmatic melt of metaluminous granite composition and an aqueous chloride fluid phase formed during the decompression degassing of magma at pressures ranging from 5 to 0.5–0.3 kbar and temperatures of 800 ± 25°C. The model accounts for the dependence of fluid/melt Cl partition coefficient on pressure and Cl content of the melt. It allows the calculation of Cl and H2O redistribution between melt and fluid during the decompression degassing of magmas under both closed-system conditions, when fluid remains in the system, and open-system conditions, when the released fluid phase is completely of partly removed from the system. The results of numerical modeling revealed the influence of the initial Cl and H2O contents in melt and the degree of system openness on variations in the concentrations of these volatiles in aqueous fluid and melt during magma ascent toward the surface under near-isothermal conditions. The highest Cl concentrations of the fluid (C Cl fl ) are attained at the early stages of decompression degassing at high pressures. With decreasing pressure, C Cl fl decreases at a rate that increases at increasing degree of system openness. During open-system degassing, the Cl content of melt (C Cl m ) also decreases. In contrast, under closed-system conditions, C Cl m decreases initially with decreasing pressure, reaches a minimum, and then increases. If decompression degassing begins at P ≤ 1.0-1.25 kbar, C Cl m changes only slightly irrespective of the initial Cl content of the melt and the degree of system openness.

3 April 2012 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
MVM. V. Volovetskii
M. V. Volovetskii
OLO. A. Lukanin
O. A. Lukanin
VRVyacheslav Serafimovich Rusakov
Vyacheslav Serafimovich Rusakov
AKA. A. Kargal’TSev
A. A. Kargal’TSev
The influence of oxygen fugacity (fO2) and temperature on the valence and structural state of iron was experimentally studied in glasses quenched from natural aluminosilicate melts of granite and pantellerite compositions exposed to various T-fO2 conditions (1100–1420°C and 10−12–10−0.68 bar) at a total pressure of 1 atm. The quenched glasses were investigated by Mössbauer spectroscopy. It was shown that the effect of oxygen fugacity on the redox state of iron at 1320–1420°C can be described by the equation log(Fe3+/Fe2+) = k log(fO2) + q, where k and q are constants depending on melt composition and temperature. The Fe3+/Fe2+ ratio decreases with decreasing fO2 (T = const) and increasing temperature (fO2 = const). The structural state of Fe3+ depends on the degree of iron oxidation. With increasing Fe3+/Fe2+ ≥ 1, the dominant coordination of Fe3+ changes from octahedral to tetrahedral. Ferrous iron ions occur in octahedral (and/or five-coordinated) sites independent of Fe3+/Fe2+.

11 August 2016 in Geochemistry International
Verified
Journal Article
Closed access
PDF file
OLO. A. Lukanin
O. A. Lukanin
An empirical computer model was developed to describe granite magma degassing and the partitioning behavior of Cl between melts and aqueous chloride fluids that formed during eutectic isobaric crystallization of magmas at pressures from 4 to 0.4 kbar and a temperature of 800 ± 25°C. This model is the extensions of the earlier model describing the decompression degassing of granite melts (Lukanin, 2015). The numerical modeling was performed for both closed-system conditions, when fluid remains in the system, and open-system conditions, when fluid is removed from the system. The results of numerical modeling revealed the main factors controlling the behavior of Cl during crystallization-induced degassing, such as the initial contents of Cl and HO of the melts, pressure, and the degree of system openness. At high pressures (>1.6 kbar), isobaric crystallization is accompanied by a decrease in the concentrations of Cl in the melt (C) and fluid phase (C). This tendency becomes even more pronounced in an open-system with increasing pressure and initial Cl content. A decrease in pressure in the range of 1.62–0.85 kbar results in a drastic change in the Cl behavior: the trend of C and C decrease dominating during crystallization at high pressures changes to the opposite. At low pressures (<0.85 kbar), the enrichment of the residual melts and released fluids in Cl leads at a certain stage of crystallization to the formation of a heterogeneous fluid consisting of two immiscible aqueous chloride phases, a waterdominated aqueous phase and a chloride-rich liquid (brine).