21 February 2021 in Nano-Micro Letters
Application of two-dimensional MXene materials in photovoltaics has attracted increasing attention since the first report in 2018 due to their metallic electrical conductivity, high carrier mobility, excellent transparency, tunable work function and superior mechanical property. In this review, all developments and applications of the Ti3C2Tx MXene (here, it is noteworthy that there are still no reports on other MXenes’ application in photovoltaics by far) as additive, electrode and hole/electron transport layer in solar cells are detailedly summarized, and meanwhile, the problems existing in the related studies are also discussed. In view of these problems, some suggestions are given for pushing exploration of the MXenes’ application in solar cells. It is believed that this review can provide a comprehensive and deep understanding into the research status and, moreover, helps widen a new situation for the study of MXenes in photovoltaics.
17 March 2017 in Nano-Micro Letters
In this study, the effect of reduced graphene oxide (rGO) on interconnected Co3O4 nanosheets and the improved supercapacitive behaviors is reported. By optimizing the experimental parameters, we achieved a specific capacitance of ~1016.4 F g−1 for the Co3O4/rGO/NF (nickel foam) system at a current density of 1 A g−1. However, the Co3O4/NF structure without rGO only delivers a specific capacitance of ~520.0 F g−1 at the same current density. The stability test demonstrates that Co3O4/rGO/NF retains ~95.5% of the initial capacitance value even after 3000 charge–discharge cycles at a high current density of 7 A g−1. Further investigation reveals that capacitance improvement for the Co3O4/rGO/NF structure is mainly because of a higher specific surface area (~87.8 m2 g−1) and a more optimal mesoporous size (4–15 nm) compared to the corresponding values of 67.1 m2 g−1 and 6–25 nm, respectively, for the Co3O4/NF structure. rGO and the thinner Co3O4 nanosheets benefit from the strain relaxation during the charge and discharge processes, improving the cycling stability of Co3O4/rGO/NF.
1 December 2021 in Electrochimica Acta
1 July 2025 in Nature Communications
Performance improvement is the cornerstone to facilitate the healthy and sustainable development of photovoltaic industry. Meanwhile, the aesthetics of solar panels becomes growingly concerned with the continuously improved requirements from customers. Accordingly, developing the modules having both a higher power conversion efficiency (PCE) and better aesthetic appearance is increasingly important. The structural advantage of back contact (BC) silicon solar cells, having a grid-line-free front surface, endows them with an exceptionally aesthetic appearance and the highest theoretical PCE among single-junction silicon solar cells. Fully utilizing these structural features is crucial for achieving high performance and gaining an insight into their industrial potential. Here, a facile double-sided light management strategy, incorporating hierarchical micro/submicrotextured pyramids on the sunny side and nanostructured polished surface in the rear gap region to reduce optical losses and improve appearance uniformity, has been developed on tunnel oxide passivated back contact (TBC) solar cells, to create a record total-area PCE of 27.03% for 350.0 cm2 commercial-sized single-junction silicon solar cells. In addition, the low bifaciality factor that is the main short slab for BC technology is overcome by our TBC devices with the bifaciality factor of > 80%.