29 April 2004 in Nuclear Fusion
22 July 2013 in Nuclear Fusion
JET underwent a transformation from a full carbon-dominated tokamak to a fully metallic device with beryllium in the main chamber and a tungsten divertor. This material combination is foreseen for the activated phase of ITER. The ITER-Like Wall (ILW) experiment at JET shall demonstrate the plasma compatibility with metallic walls and the reduction in fuel retention. We report on a set of experiments (Ip = 2.0 MA, Bt = 2.0–2.4 T, δ = 0.2–0.4) in different confinement and plasma conditions with global gas balance analysis demonstrating a strong reduction in the long-term retention rate by more than a factor of 10 with respect to carbon-wall reference discharges. All experiments are executed in a series of identical plasma discharges in order to achieve maximum plasma duration until the analysis limit of the active gas handling system is reached. The composition analysis shows high purity of the recovered gas, typically 99% D. For typical L-mode discharges (Paux = 0.5 MW), type III (Paux = 5.0 MW) and type-I ELMy H-mode plasmas (Paux = 12.0 MW) a drop of the deuterium retention rate normalized to the operational time in divertor configuration is measured from 1.27 × 1021, 1.37 × 1021 and 1.97 × 1021 D s−1 down to 4.8 × 1019, 7.2 × 1019 and 16 × 1019 D s−1, respectively. The dynamic retention increases in the limiter phase in comparison with carbon-fibre composite, but also the outgassing after the discharge has risen in the same manner and overcompensates this transient retention. Overall an upper limit of the long-term retention rate of 1.5 × 1020 D s−1 is obtained with the ILW. The observed reduction by one order of magnitude confirms the expected predictions concerning the plasma-facing material change in ITER and is in line with identification of fuel co-deposition with Be as the main mechanism for the residual long-term retention. The reduction widens the operational space without active cleaning in the DT phase in comparison with a full carbon device.
27 September 2013 in Nuclear Fusion
12 September 2003 in Nuclear Fusion
23 January 2014 in Nuclear Fusion
30 June 2003 in Plasma Physics and Controlled Fusion
ELM-free H-mode plasmas with stationary plasma density and radiation level are obtained in the ASDEX Upgrade tokamak with large clearance between the last closed flux surface and the wall, and neutral beam injection in a toroidal direction opposite to that of the plasma current. This behaviour is accompanied by a characteristic narrow-band magnetohydrodynamic (MHD) oscillation with clear harmonics up to n = 11 visible. This mode is localized in the plasma edge region. Conditions and properties of the stationary ELM-free phases and the edge MHD oscillation closely resemble that of the `quiescent H-mode' and the `edge harmonic oscillation' found in the DIII-D tokamak (Burrell K H et al 2002 Plasma Phys. Control. Fusion 44 A253). In addition, high-frequency MHD oscillations are found with an amplitude correlated with fluctuations of the divertor Dα intensity, suggesting a possible relevance of these modes for particle transport.