The aim of this study was to evaluate the stress distribution in the bone around dental and zygomatic implants for 4 different implant-supported obturator prostheses designs in a unilaterally maxillary defect using a 3-dimensional finite element stress analysis. A 3-dimensional finite element model of the human unilateral maxillary defect was constructed. Four different implant-supported obturator prostheses were modeled; model 1 with 2 zygomatic implants and 1 dental implant, model 2 with 2 zygomatic implants and 2 dental implants, model 3 with 2 zygomatic implants and 3 dental implants, and model 4 with 1 zygomatic implant and 3 dental implants. Bar attachments were used as superstructure. A 150-N vertical load was applied in 3 different ways, and von Mises stresses in the cortical bone around implants were evaluated. When the models (model 1–3) were compared in terms of number of implants, all of the models showed similar highest stress values under the first loading condition, and these values were less than under model 4 conditions. The highest stress values of models 1–4 under the first loading condition were 8.56, 8.59, 8.32, and 11.55 Mpa, respectively. The same trend was also observed under the other loading conditions. It may be concluded that the use of a zygomatic implant on the nondefective side decreased the highest stress values, and increasing the number of dental implants between the most distal and most mesial implants on the nondefective side did not decrease the highest stress values.
1 January 2013 in The Journal of Advanced Prosthodontics
Aim: The purpose of this study was to evaluate the effect of different surface treatments on the bond strength of veneering ceramic to zirconia. Methods: Square (15 mm x 10 mm x 2 mm) zirconia specimens (n=18) received one of the following surface treatments: Group 1, sandblasting; Group 2, Clearfil ceramic primer application; Group 3, grinding; Group 4, alloy primer application; and Group 5, RelyX ceramic primer application. The zirconia core specimens were layered with a veneering porcelain (5 mm x 3 mm x 3 mm). Mean shear bond strength values (MPa) were calculated. Data were analyzed with one-way ANOVA and Tukey's post hoc pairwise comparisons (α=0.05). Fractured surfaces of the specimens were examined with scanning electron microscope (SEM). Results: This study showed that bond strengths of the metal primer-treated zirconia specimens (Group 4) were significantly higher than those of the other paired groups. The application of metal primer affected the specimens' failure mode. SEM analysis demonstrated that Group 4 had mainly cohesive fractures, while the other groups showed approximately equal levels of adhesive and mixed fracture types. The mean and SD values for shear bond strengths ranged from 8.90 ± 3.42 MPa (Group 2) to 19.74 ± 4.96 MPa (Group 4). Conclusions: In conclusion, the application of a metal primer to a zirconia core increased the bond strength of veneering ceramics. The use of chemical agents to improve the strength of the zirconia core's bond to veneering ceramic may have more benefits than the use of mechanical pretreatments.