7 July 2020 in Metallurgical and Materials Transactions B
13 May 2014 in Metallurgical and Materials Transactions E
The development of recycling technologies for rare earths is essential for resource security and supply stability because high-quality rare earth mines are concentrated in China and the demand for rare earth metals such as neodymium and dysprosium, used as raw materials in permanent magnets (neodymium magnet), is expected to increase rapidly in the near future. It is also important to establish a recycling-based society from the perspective of the conservation of finite and valuable mineral resources and the reduction of the environmental load associated with mining and smelting. In this article, the current status of rare earth resource as well as that of recycling technology for the magnets is reviewed. The importance of establishing an efficient recycling process for rare earths is discussed from the characteristics of supply chain of rare earths, and the technological bases of the recycling processes for the magnet are introduced. Further, some fundamental researches on the development of new recycling processes based on pyrometallurgical process are introduced, and the features of the recycling processes are evaluated.
29 October 2018 in Journal of Sustainable Metallurgy
14 January 2015 in International Journal of Thermophysics
15 March 2020 in ISIJ International
A rotating crucible viscometer previously developed by the authors was improved in order to measure wide-range of viscosity values with high reliability. Two sets of inner cylinder and crucible with different geometries were employed as an attempt to accomplish this objective. The centers of these components were matched with accuracy of ± 0.1 mm by adopting X-Y stage for positioning. Relative error in torque measurement was less than 1.5%, and calibration curves had a good consistency for all experiments. By using the improved viscometer, a typical molten salt, LiF–10 mol% NaF–45 mol% KF (FLiNaK), a high-temperature low viscosity liquid, was measured and the results agreed with the theoretical values estimated from pure substances relations. Viscosity of the SiO2–Na2O–NaF system (CNa2O/CSiO2 = 0.67 in mol%) was obtained by varying concentration range from 0 to 80 mol% NaF. All melts’ composition tested followed Arrhenius-type temperature dependence, and a viscosity relation at 1473 K based on composition was also obtained. Drastic decreases in activation energy for viscous flow were observed at the concentrations of 5 and 80 mol% NaF.