State Key Laboratory of Advanced Electromagnetic Technology, School of Electrical and Electronic Engineering, Huazhong University of Science and Technology, Wuhan, 430074, P. R. China
Auto-generated profile, based on publicly available information
Jia Xie
State Key Laboratory of Advanced Electromagnetic Technology, School of Electrical and Electronic Engineering, Huazhong University of Science and Technology, Wuhan, 430074, P. R. China
In energy storage devices, the critical demands for high energy/power density, low cost, long cycle lives and environmental friendliness have highlighted an urgent need for developing storage electrodes with low cost, large thickness, high mass loading, low tortuosity and high energy/power density. Here we demonstrate the design and construction of an all-wood-structured asymmetric supercapacitor (ASC) based on an activated wood carbon (AWC) anode, a wood membrane separator and a MnO2/wood carbon (MnO2@WC) cathode. The structural virtues of the all-wood-structured ASC device – desirable thickness (up to ∼1 mm), direct channels with low tortuosity, high electronic and ionic conductivity – enable ASC high areal mass loadings (up to 30 mg cm−2 for the anode and 75 mg cm−2 for the wood carbon/MnO2 composite cathode), a high energy density of 1.6 mW h cm−2 and a maximum power density of 24 W cm−2, representing the highest mass loading and areal energy/power densities among all reported MnO2-based supercapacitors. Moreover, all components in the all-wood-structured ASC are low-cost, environmentally friendly and biocompatible. With these unique features, the all-wood-structured ASC represents a promising energy storage device to realize high mass loading, high energy/power density, and biocompatibility for green and renewable energy storage.
Sulfurized polyacrylonitrile is suggested to contain Sn (n ≤ 4) and shows good electrochemical performance in carbonate electrolytes for lithium sulfur batteries. However inferior results in ether electrolytes suggest that high solubility of Li2Sn (n ≤ 4) trumps the limited redox conversion, leading to dissolution and shuttling. Here, we introduce a small amount of selenium in sulfurized polyacrylonitrile to accelerate the redox conversion, delivering excellent performance in both carbonate and ether electrolytes, including high reversible capacity (1300 mA h g−1 at 0.2 A g−1), 84% active material utilization and high rate (capacity up to 900 mA h g−1 at 10 A g−1). These cathodes can undergo 800 cycles with nearly 100% Coulombic efficiency and ultralow 0.029% capacity decay per cycle. Polysulfide dissolution is successfully suppressed by enhanced reaction kinetics. This work demonstrates an ether compatible sulfur cathode involving intermediate Li2Sn (n ≤ 4), attractive rate and cycling performance, and a promising solution towards applicable lithium-sulfur batteries.