The influence of deposition conditions on the antireflection properties of diamond-like carbon films for Si-based solar cells is studied theoretically. The values of the short-circuit current density for Si solar cells covered by diamond-like carbon films deposited at different concentrations of nitrogen in the gas mixture are calculated and compared with the associated values for uncovered solar cells. It is shown that the short-circuit current density increases with nitrogen concentration in the gas mixture because of a lower light absorption by the growing film. Optimum thicknesses of the diamond-like carbon films are calculated that provides a maximal increase in the output short-circuit current density of Si-based solar cells under both AM1.5 and AM0 conditions.
The relative change in the coefficient of efficiency is chosen as a criterion for contamination of the glass surface of a photovoltaic battery. Using the formula obtained, the results of measurements of the transmission coefficient of a contaminated glass plate after its exposure to open air in the center of Tashkent for 80 and 110 days are processed. It is shown that the contamination of the glass plate reduces the coefficient of efficiency of the PVB by 50.0%.
The paper presents the results of measurements of coating reflection coefficients. These coatings are based on a mixture of germanium with germanium oxide
The influence of convective heat exchange on the temperature of a solarvoltaic array (SVA) is studied. It is shown that the temperature of a SVA depends significantly on the wind velocity if the temperature of the environment is less than 30°C; the temperature decreases by 40%, while the wind velocity increases from 1 to 10 m/s. In this case use of a photo heat-regenerating unit is inefficient. If the environmental temperature is more than 30°C, then the change of the SVA temperature depends slightly on the wind velocity and it is necessary to cool it for the efficient operation of the SVA. At a wind velocity of less than 2 m/s the SVA is cooled both due to convective and radiation heat exchange. At a wind velocity of more than 2 m/s the convective heat exchange prevails over the radiation heat exchange.
Results are presented obtained in measurements of current–voltage characteristics of organic solar cells with and without antiref lection coatings produced by melting in a solar furnace of 95 : 5 and...
A mixed alloy of TiO2 and SiO2 has been obtained using a 3-kW solar furnace. Films of the TiO2-SiO2 alloy applied onto a surface of glass and silicon plates exhibit high strength and adhesion, are transparent in the spectral range of sensitivity of solar cells, and can be used as effective antireflection coatings. It is established that adding TiO2 to SiO2 improves the optical properties of oxide coatings.